DQRID : D120913.2
Start DateStart TimeEnd DateEnd Time Data Quality Metric
01/29/2012200002/14/20121800Incorrect
more
Subject:
NSA/KAZR/C1 - PLO Failure
DataStreams:nsakazrspeccmaskhicopolC1.a0, nsakazrspeccmaskgecopolC1.a0, nsakazrspeccmaskmdcopolC1.a0,
nsakazrspeccmaskhixpolC1.a0, nsakazrspeccmaskmdxpolC1.a0, nsakazrmdC1.a1,
nsakazrhiC1.a1, nsakazrspeccmaskgexpolC1.a0, nsakazrauxC1.a0, nsakazrgeC1.a1
Description:
Streaks began showing up in radar data (reflectivity, doppler velocity, spectral width, 
SNR) at semi regular intervals.  Problem was a failed 16.560 GHz Phase Lock Oscillator 
(PLO).  PLO was replaced 20120214.
Suggestions: 
Data should be used for qualitative purposes only due to the "streakiness" in the data..
Measurements:nsakazrgeC1.a1:
  • signal_to_noise_ratio_copol
  • mean_doppler_velocity_xpol
  • signal_to_noise_ratio_xpol
  • spectral_width_xpol
  • mean_doppler_velocity_copol
  • reflectivity_xpol
  • spectral_width_copol
  • reflectivity_copol
more
nsakazrauxC1.a0:
  • temp_lna
  • power_supply_5p2V
  • temp_circulator
  • lock_alarm_16560
  • temp_component_plate
  • temp_noise_diode
  • time
  • time_offset
  • lon
  • rh_local
  • cal_constant_ch2_copol
  • fft_taper_type
  • input_15V
  • input_5V
  • temp_power_supply
  • temp_antenna_feedhorn
  • input_minus5V
  • helix_current
  • rx_gain_ch1
  • rx_gain_ch2
  • twta_latest_fault_time_epoch
  • power_supply_28V
  • temp_antenna
  • temp_reverse_power
  • rx_noise_ch2
  • rx_noise_ch1
  • rh_antenna
  • remote_control_enabled
  • alt
  • collector_voltage
  • is_powered_on
  • cal_constant_ch1_copol
  • base_time
  • twta_status_is_valid
  • cal_constant_ch1_xpol
  • input_8V
  • cathode_voltage
  • lock_alarm_120
  • power_supply_5V
  • lock_alarm_360
  • lock_alarm_1620
  • fault_flags
  • temp_local
  • temp_rf_detector
  • temp_outside_air
  • timing_mode
  • tx_power
  • input_12V
  • twta_status_state
  • lat
  • filament_voltage
  • cal_constant_ch2_xpol
  • processing_mode
  • noise_source_ch2
  • noise_source_ch1
more
nsakazrspeccmaskmdcopolC1.a0:
  • reflectivity
  • mean_doppler_velocity
  • signal_to_noise_ratio
  • spectral_width
more
nsakazrhiC1.a1:
  • spectral_width_copol
  • reflectivity_copol
  • spectral_width_xpol
  • signal_to_noise_ratio_copol
  • signal_to_noise_ratio_xpol
  • mean_doppler_velocity_copol
  • mean_doppler_velocity_xpol
  • reflectivity_xpol
more
nsakazrspeccmaskhicopolC1.a0:
  • spectral_width
  • reflectivity
  • signal_to_noise_ratio
  • mean_doppler_velocity
more
nsakazrspeccmaskhixpolC1.a0:
  • signal_to_noise_ratio
  • mean_doppler_velocity
  • reflectivity
  • spectral_width
more
nsakazrmdC1.a1:
  • mean_doppler_velocity_copol
  • reflectivity_copol
  • mean_doppler_velocity_xpol
  • reflectivity_xpol
  • spectral_width_xpol
  • spectral_width_copol
  • signal_to_noise_ratio_copol
  • signal_to_noise_ratio_xpol
more
nsakazrspeccmaskmdxpolC1.a0:
  • signal_to_noise_ratio
  • mean_doppler_velocity
  • reflectivity
  • spectral_width
more
nsakazrspeccmaskgexpolC1.a0:
  • mean_doppler_velocity
  • reflectivity
  • signal_to_noise_ratio
  • spectral_width
more
nsakazrspeccmaskgecopolC1.a0:
  • reflectivity
  • signal_to_noise_ratio
  • spectral_width
  • mean_doppler_velocity
more

Close this window