PYE/SKYRAD/M1 - IRT bias

The SKYRAD IRT measured lower sky temperatures than the AERI.  This may have been due to a 
dirty mirror or lens.

• Sky/Cloud Infra-Red Temperature Minima(sky_ir_temp_min)
• Sky/Cloud Infra-Red Temperature Maxima(sky_ir_temp_max)
• Sky/Cloud Infra-Red Temperature Standard Deviation(sky_ir_temp_std)
• Sky/Cloud Infra-Red Temperature(sky_ir_temp)

PYE/SKYRAD/M1 - Reprocess: Longwave Calibration error

Modified pyrgeometer calibration procedures were implemented beginning in December 2003.  
These modified procedures introduced a calibration bias in the longwave data.  The 
previous procedures were re-implemented at all sites between December 2005 and February 2006 to 
restore proper calibrations.                                                             
                The data collected while the incorrect procedures were in place are 
being reprocessing to remove the calibration bias.  Note, this also affected standard 
deviation, maximum and minimum data fields.

• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer2(down_long_hemisp_shaded2)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer1(down_long_hemisp_shaded1)

PYE/SKYRAD/M1 - Datalogger program error affected downwelling longwave

The excitation delays used in measuring the PIR1 case thermistor, "Case1", and the PIR2 
dome thermistor, "Dome2", were discovered to have been incorrectly set to 0 in the Skyrad 
datalogger program when the new CR23X based Skyrad loggers were installed.  The result of 
no delay in these measurements results in an error in the measured resistance of the 
thermistors, Case1 and Dome2, and thus the calculated PIR1 and PIR2 irradiances.  The 
absolute value of the errors are inversely proportial to temperature.

At Pt Reyes, we are unable to determine if the excitation delay problem was present.  The 
first Skyrad datalogger program installed at PYE was correct but later versions modified 
and uploaded in March and April of 2005 may have had the Delay0 problem.

The problem also can not be determined from the data.  Pt. Reyes temperature fluctuations 
throughout the year are maritime and fall into a relatively narrow range in 2005 between 
2.5-20C.  The Delay0 problem introduces larger errors into PIR1 and PIR2 irradiance 
calculations as the temperature drops.  At the lowest temperature at Pt Reyes in 2005 (approx 
2.5C occurring in March) the largest PIR1 error would be -.48 W/m2 and PIR2 +.38 W/m2.  
The scale of these errors are smaller than the resolution of the instrument and are lost 
in the normal variation of the instrument readings. Cursory review of the thermistor data 
during cold periods does not show any discernable biases.  Furthermore, the data logger 
programming "error" due to the Delay0 problem is an order of magnitude less than the total 
estimated measurement uncertainty of the pyrgeometer data from any ARM installation (+/- 
5 W/sq m for 4-coeff and +/- 10 W/sq m for 2-coeff calibrations).

Due to these issues, no Delay0 corrections will be applied to PYE Skyrad data.

• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer2, Standard
  Deviation(down_long_hemisp_shaded2_std)
• Instantaneous Downwelling Pyrgeometer Case Thermistor Temperature, Shaded
  Pyrgeometer1(inst_down_long_shaded1_case_temp)
• Instantaneous Downwelling Pyrgeometer Dome Thermistor Temperature, Shaded
  Pyrgeometer2(inst_down_long_shaded2_dome_temp)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer2(down_long_hemisp_shaded2)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer1(down_long_hemisp_shaded1)
• Instantaneous Downwelling Pyrgeometer Thermopile, Shaded Pyrgeometer2(inst_down_long_hemisp_shaded2_tp)
• Instantaneous Downwelling Pyrgeometer Thermopile, Shaded Pyrgeometer1(inst_down_long_hemisp_shaded1_tp)
• Instantaneous Downwelling Pyrgeometer Dome Thermistor Temperature, Shaded
  Pyrgeometer1(inst_down_long_shaded1_dome_temp)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer1, Minima(down_long_hemisp_shaded1_min)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer1, Standard
  Deviation(down_long_hemisp_shaded1_std)
• Instantaneous Downwelling Pyrgeometer Case Thermistor Temperature, Shaded
  Pyrgeometer2(inst_down_long_shaded2_case_temp)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer2, Minima(down_long_hemisp_shaded2_min)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer1, Maxima(down_long_hemisp_shaded1_max)
• Downwelling Longwave Hemispheric Irradiance, Shaded Pyrgeometer2, Maxima(down_long_hemisp_shaded2_max)

• Instantaneous Downwelling Pyrgeometer Dome Thermistor Resistance, Shaded
  Pyrgeometer1(inst_down_long_shaded1_dome_resist)
• Instantaneous Downwelling Pyrgeometer Dome Thermistor Resistance, Shaded
  Pyrgeometer2(inst_down_long_shaded2_dome_resist)
• Instantaneous Downwelling Pyrgeometer Case Thermistor Resistance, Shaded
  Pyrgeometer1(inst_down_long_shaded1_case_resist)
• Instantaneous Downwelling Pyrgeometer Case Thermistor Resistance, Shaded
  Pyrgeometer2(inst_down_long_shaded2_case_resist)
• Instantaneous Downwelling Pyrgeometer Thermopile, Shaded Pyrgeometer1(inst_down_long_hemisp_shaded1_tp)
• Instantaneous Downwelling Pyrgeometer Thermopile, Shaded Pyrgeometer2(inst_down_long_hemisp_shaded2_tp)