DQR ID | Subject | Data Streams Affected |
---|---|---|
D060208.2 | SGP/SONDE/C1 - Mixed use of RS92-SGP and RS92-KL radiosondes | sgpsondewnpnC1.b1 |
D060928.3 | SGP/SONDE/C1 - Increased precision for alt, dp, pres, rh, tdry | sgpsondewnpnC1.b1 |
D061201.1 | SGP/SONDE/C1 - RH Sensor failure | sgpsondewnpnC1.b1 |
Start Date | Start Time | End Date | End Time |
---|---|---|---|
02/10/2006 | 0000 | 12/31/2006 | 2359 |
Subject: | SGP/SONDE/C1 - Mixed use of RS92-SGP and RS92-KL radiosondes |
DataStreams: | sgpsondewnpnC1.b1 |
Description: | Because of a manufacturer's production problem, we will be using both RS92-SGP (GPS windfinding and RS92-KL (Loran windfinding) radiosondes at the SGP/CF starting February 10, 2006. The radiosonde type used for the each sounding may be determined by looking the metadata variable "launch_status" in the netCDF data files. |
Measurements: | sgpsondewnpnC1.b1:
|
Start Date | Start Time | End Date | End Time |
---|---|---|---|
09/28/2006 | 1728 | 12/31/9999 | 2359 |
Subject: | SGP/SONDE/C1 - Increased precision for alt, dp, pres, rh, tdry |
DataStreams: | sgpsondewnpnC1.b1 |
Description: | The output precision of the following variables was increased 20060928 alt changed from 1m to 0.1m dp changed from 0.1degC to 0.01degC pres changed from 0.1 hPa to 0.01 hPa RH changed from 1%RH to 0.01%RH tdry changed from .1degC to 0.01degC Note that the increase in precision does not necessarily imply an increase in accuracy. Users are cautioned to continue to use their best scientific judgement when using these or any other data. |
Measurements: | sgpsondewnpnC1.b1:
|
Start Date | Start Time | End Date | End Time |
---|---|---|---|
11/27/2006 | 2331 | 11/28/2006 | 0056 |
Subject: | SGP/SONDE/C1 - RH Sensor failure |
DataStreams: | sgpsondewnpnC1.b1 |
Description: | The differences between the two RH sensors on this sonde are unreasonably high (~20%). As a result the reported RH values oscillate by this amount during the times the sensors are alternately heated. After the heating stops, the reported RH comes from the sensor reading the higher value. There is no way of knowing if this is the correct value. |
Measurements: | sgpsondewnpnC1.b1:
|