Data Quality Reports for Session: 114031 User: perez Completed: 09/08/2008


TABLE OF CONTENTS

DQR IDSubjectData Streams Affected
D050725.11TWP/MWR/C3 - Reprocess - Revised Retrieval CoefficientstwpmwrlosC3.a1, twpmwrlosC3.b1, twpmwrtipC3.a1
D050928.5TWP/MWR/C3 - New software version (4.15) installedtwpmwrlosC3.b1, twpmwrtipC3.a1
D051214.1TWP/MWR/C3 - REPROCESS- Updated retrieval coefficientstwpmwrlosC3.b1, twpmwrtipC3.a1


DQRID : D050725.11
Start DateStart TimeEnd DateEnd Time
02/27/2002015106/30/20052100
Subject:
TWP/MWR/C3 - Reprocess - Revised Retrieval Coefficients
DataStreams:twpmwrlosC3.a1, twpmwrlosC3.b1, twpmwrtipC3.a1
Description:
IN THE BEGINNING (June 1992), the retrieval coefficients used to derive 
the precipitable water vapor (PWV) and liquid water path (LWP) from the 
MWR brightness temperatures were based on the Liebe and Layton (1987) 
water vapor and oxygen absorption model and the Grant (1957) liquid 
water absorption model.

Following the SHEBA experience, revised retrievals based on the more 
recent Rosenkranz (1998) water vapor and oxygen absorption models and 
the Liebe (1991) liquid waer absorption model were developed.  The 
Rosenkranz water vapor absorption model resulted a 2 percent increase 
in PWV relative to the earlier Liebe and Layton model.  The Liebe 
liquid water absorption model decreased the LWP by 10% relative to the 
Grant model.  However, the increased oxygen absorption caused a 
0.02-0.03 mm (20-30 g/m2) reduction in LWP, which was particularly 
significant for low LWP conditions (i.e. thin clouds encountered at 
SHEBA).

Recently, it has been shown (Liljegren, Boukabara, Cady-Pereira, and 
Clough, TGARS v. 43, pp 1102-1108, 2005) that the half-width of the 
22 GHz water vapor line from the HITRAN compilation, which is 5 percent 
smaller than the Liebe and Dillon (1969) half-width used in Rosenkranz 
(1998), provided a better fit to the microwave brightness temperature 
measurements at 5 frequencies in the range 22-30 GHz, and yielded more 
accurate retrievals. Accordingly, revised MWR retrieval coefficients 
have been developed using MONORTM, which utilizes the HITRAN compilation 
for its spectroscopic parameters.  These new retrievals provide 3 
percent less PWV and 2.6 percent greater LWP than the previous 
retrievals based on Rosenkranz (1998).

Although the MWR data will be reprocessed to apply the new monortm-based 
retrievals, for most purposes it will be sufficient to correct the data 
using the following factors:

PWV_MONORTM = 0.9695 * PWV_ROSENKRANZ
LWP_MONORTM = 1.026  * LWP_ROSENKRANZ

The Rosenkranz-based retrieval coefficients was active at TWP.C3 from
inception of the data, 20020227.0151.  The MONORTM-based retrieval
coefficients became active at TWP.C3 20050630.2100.

Note: a reprocessing effort is already underway to apply the 
Rosenkranz-based retrieval coefficients to all MWR prior to April 
2002.  An additional reprocessing task will be undertaken to apply 
the MONORTM retrieval to all MWR data when the first is completed. 
Read reprocessing comments in the netcdf file header carefully to 
ensure you are aware which retrieval is in play.
Measurements:twpmwrlosC3.a1:
  • MWR column precipitable water vapor(vap)
  • Averaged total liquid water along LOS path(liq)

twpmwrlosC3.b1:
  • MWR column precipitable water vapor(vap)
  • Averaged total liquid water along LOS path(liq)

twpmwrtipC3.a1:
  • Total water vapor along zenith path using tip-derived brightness temperatures(vaptip)
  • Total liquid water along zenith path using tip-derived brightness temperatures(liqtip)


Back To Table of Contents

DQRID : D050928.5
Start DateStart TimeEnd DateEnd Time
10/03/2002000009/20/20052156
Subject:
TWP/MWR/C3 - New software version (4.15) installed
DataStreams:twpmwrlosC3.b1, twpmwrtipC3.a1
Description:
A problem began with the installation of MWR.EXE version 4.12 in October 2002. The 
software had been upgraded from a "DOS" to a "Windows"-compiled program to address an earlier 
problem.  The software upgrade corrected the earlier problem but introduced a new one that 
caused line-of-sight observing cycles to be skipped, a 15% reduction in the number of tip 
curves, and saturation of CPU usage.  Software versions 4.13 and 4.14 also produced 
these problems.

The new MWR software version (4.15) was installed on 9/20/2005. As a consequence of this 
upgrade, the tip curve frequency increased. The tip cycle time decreased from ~60s to ~50s.
Measurements:twpmwrlosC3.b1:
  • Sky brightness temperature at 31.4 GHz(tbsky31)
  • 23.8 GHz blackbody+noise injection signal(bbn23)
  • Noise injection temp at nominal temperature at 23.8 GHz(tnd_nom23)
  • 31.4 GHz blac2body+noise injection signal(bbn31)
  • Temperature correction coefficient at 23.8 GHz(tc23)
  • 23.8 GHz Blackbody signal(bb23)
  • MWR column precipitable water vapor(vap)
  • Averaged total liquid water along LOS path(liq)
  • 31.4 GHz blackbody(bb31)
  • 31.4 GHz sky signal(sky31)
  • 23.8 GHz sky signal(sky23)
  • Sky brightness temperature at 23.8 GHz(tbsky23)
  • Noise injection temp at nominal temperature at 31.4 GHz(tnd_nom31)
  • Temperature correction coefficient at 31.4 GHz(tc31)
  • Noise injection temp at 31.4 GHz adjusted to tkbb(tnd31)
  • Sky Infra-Red Temperature(sky_ir_temp)
  • Blackbody kinetic temperature(tkbb)
  • Mixer kinetic (physical) temperature(tkxc)
  • (tknd)
  • Ambient temperature(tkair)
  • Noise injection temp at 23.8 GHz adjusted to tkbb(tnd23)

twpmwrtipC3.a1:
  • Ambient temperature(tkair)
  • Blackbody kinetic temperature(tkbb)
  • (tknd)
  • Temperature correction coefficient at 31.4 GHz(tc31)
  • Noise injection temp at nominal temperature at 31.4 GHz(tnd_nom31)
  • 23.8 GHz sky brightness temperature derived from tip curve(tbskytip23)
  • Noise injection temp at nominal temperature at 23.8 GHz(tnd_nom23)
  • Total water vapor along zenith path using tip-derived brightness temperatures(vaptip)
  • Noise injection temp at 31.4 GHz derived from this tip(tnd31I)
  • Temperature correction coefficient at 23.8 GHz(tc23)
  • 23.8 GHz sky signal(tipsky23)
  • Noise injection temp at 31.4 GHz adjusted to tkbb(tnd31)
  • 31.4 GHz blackbody(bb31)
  • 31.4 GHz goodness-of-fit coefficient(r31)
  • 31.8 GHz sky brightness temperature derived from tip curve(tbskytip31)
  • 23.8 GHz blackbody+noise injection signal(bbn23)
  • Total liquid water along zenith path using tip-derived brightness temperatures(liqtip)
  • Mixer kinetic (physical) temperature(tkxc)
  • 31.4 GHz blac2body+noise injection signal(bbn31)
  • Noise injection temp at 23.8 GHz derived from this tip(tnd23I)
  • 31.4 GHz sky signal(tipsky31)
  • 23.8 GHz goodness-of-fit coefficient(r23)
  • Noise injection temp at 23.8 GHz adjusted to tkbb(tnd23)
  • 23.8 GHz Blackbody signal(bb23)


Back To Table of Contents

DQRID : D051214.1
Start DateStart TimeEnd DateEnd Time
02/27/2002000012/12/20051600
Subject:
TWP/MWR/C3 - REPROCESS- Updated retrieval coefficients
DataStreams:twpmwrlosC3.b1, twpmwrtipC3.a1
Description:
The statistical retrieval coefficients currently in use at the Darwin (TWP/C3) site were 
developed using radiosonde RS80 launched from Manus Island during the TOGA-COARE 
experiment.
Data from Manus Island have minimal seasonality, therefore a single, annual set of 
coefficients was used at all three sites. Retrievals using these coefficients are sufficiently 
accurate especially during the local summer months (December-January). However, the Darwin 
site displays a summer/winter seasonality resulting in larger differences during the 
southern winter (May-
June).
Since we now have enough radiosonde soundings (RS80 and RS90) available at the Darwin 
site, the Darwin coefficients were modified to better reflect the local seasonality.
Measurements:twpmwrlosC3.b1:
  • MWR column precipitable water vapor(vap)
  • Averaged total liquid water along LOS path(liq)

twpmwrtipC3.a1:
  • Total water vapor along zenith path using tip-derived brightness temperatures(vaptip)
  • Total liquid water along zenith path using tip-derived brightness temperatures(liqtip)


Back To Table of Contents



END OF DATA