DQRID : D140214.3
Start DateStart TimeEnd DateEnd Time Data Quality Metric
12/01/2013050001/14/20142022Missing
more
Subject:
SGP/KAZR/C1 - Disk error/failure
DataStreams:sgpkazrauxC1.a0, sgpkazrgeC1.a1, sgpkazrspeccmaskmdxpolC1.a0, sgpkazrspeccmaskgexpolC1.a0,
sgpkazrC1.00, sgpkazrspeccmaskhicopolC1.a0, sgpkazrhiC1.a1,
sgpkazrspeccmaskhixpolC1.a0, sgpkazrmdC1.a1, sgpkazrspeccmaskmdcopolC1.a0, sgpkazrspeccmaskgecopolC1.a0
Description:
Sectors on the KAZR's spectra storage partition are causing some data files to be 
corrupted.  This has caused collections to fail, the disk to fill, and subsequent data loss.
Suggestions: 
Measurements:sgpkazrC1.00:
  • Raw data stream - documentation not supported
more
sgpkazrspeccmaskmdxpolC1.a0:
  • spectra
  • locator_mask
  • lat
  • velocity_bins
  • lon
  • time_offset
  • alt
  • range
  • reflectivity
  • mean_doppler_velocity
  • spectral_width
  • base_time
  • time
  • signal_to_noise_ratio
more
sgpkazrspeccmaskhicopolC1.a0:
  • lat
  • locator_mask
  • time_offset
  • alt
  • signal_to_noise_ratio
  • time
  • mean_doppler_velocity
  • reflectivity
  • spectral_width
  • velocity_bins
  • base_time
  • range
  • lon
  • spectra
more
sgpkazrgeC1.a1:
  • lon
  • mean_doppler_velocity_copol
  • base_time
  • time_offset
  • hot_noise_xpol
  • spectral_width_copol
  • spectral_width_xpol
  • mean_doppler_velocity_xpol
  • rx_noise
  • range
  • reflectivity_copol
  • cal_constant_copol
  • signal_to_noise_ratio_xpol
  • cal_constant_xpol
  • sky_noise_copol
  • cold_noise_copol
  • signal_to_noise_ratio_copol
  • time
  • cold_noise_xpol
  • lat
  • reflectivity_xpol
  • sky_noise_xpol
  • alt
  • hot_noise_copol
more
sgpkazrspeccmaskgecopolC1.a0:
  • time
  • lon
  • mean_doppler_velocity
  • alt
  • lat
  • locator_mask
  • time_offset
  • signal_to_noise_ratio
  • spectral_width
  • velocity_bins
  • spectra
  • base_time
  • range
  • reflectivity
more
sgpkazrspeccmaskhixpolC1.a0:
  • velocity_bins
  • spectral_width
  • lon
  • signal_to_noise_ratio
  • base_time
  • mean_doppler_velocity
  • time_offset
  • time
  • spectra
  • reflectivity
  • range
  • lat
  • alt
  • locator_mask
more
sgpkazrspeccmaskgexpolC1.a0:
  • time
  • alt
  • lat
  • locator_mask
  • signal_to_noise_ratio
  • lon
  • base_time
  • time_offset
  • spectral_width
  • mean_doppler_velocity
  • spectra
  • reflectivity
  • range
  • velocity_bins
more
sgpkazrauxC1.a0:
  • input_12V
  • cal_constant_ch1_xpol
  • time_offset
  • temp_lna
  • cal_constant_ch2_copol
  • power_supply_28V
  • twta_status_is_valid
  • tx_power
  • power_supply_5p2V
  • power_supply_5V
  • lock_alarm_1620
  • temp_component_plate
  • input_5V
  • temp_noise_diode
  • fault_flags
  • input_15V
  • temp_reverse_power
  • temp_local
  • processing_mode
  • lon
  • fft_taper_type
  • temp_antenna_feedhorn
  • helix_current
  • lock_alarm_16560
  • temp_rf_detector
  • noise_source_ch2
  • noise_source_ch1
  • cathode_voltage
  • rx_gain_ch1
  • rx_gain_ch2
  • remote_control_enabled
  • time
  • input_8V
  • temp_power_supply
  • base_time
  • collector_voltage
  • temp_outside_air
  • timing_mode
  • rh_local
  • cal_constant_ch2_xpol
  • twta_latest_fault_time_epoch
  • input_minus5V
  • alt
  • lat
  • cal_constant_ch1_copol
  • filament_voltage
  • rh_antenna
  • is_powered_on
  • lock_alarm_120
  • lock_alarm_360
  • rx_noise_ch2
  • rx_noise_ch1
  • temp_antenna
  • temp_circulator
  • twta_status_state
more
sgpkazrmdC1.a1:
  • reflectivity_xpol
  • reflectivity_copol
  • spectral_width_xpol
  • rx_noise
  • cold_noise_xpol
  • time
  • base_time
  • time_offset
  • hot_noise_xpol
  • cal_constant_copol
  • mean_doppler_velocity_xpol
  • sky_noise_xpol
  • lat
  • hot_noise_copol
  • cold_noise_copol
  • alt
  • cal_constant_xpol
  • mean_doppler_velocity_copol
  • sky_noise_copol
  • signal_to_noise_ratio_xpol
  • lon
  • spectral_width_copol
  • range
  • signal_to_noise_ratio_copol
more
sgpkazrspeccmaskmdcopolC1.a0:
  • spectral_width
  • locator_mask
  • spectra
  • base_time
  • velocity_bins
  • time
  • alt
  • lat
  • time_offset
  • lon
  • mean_doppler_velocity
  • reflectivity
  • signal_to_noise_ratio
  • range
more
sgpkazrhiC1.a1:
  • sky_noise_copol
  • reflectivity_xpol
  • reflectivity_copol
  • spectral_width_copol
  • rx_noise
  • alt
  • lat
  • signal_to_noise_ratio_copol
  • base_time
  • lon
  • mean_doppler_velocity_copol
  • sky_noise_xpol
  • signal_to_noise_ratio_xpol
  • spectral_width_xpol
  • time
  • time_offset
  • cold_noise_copol
  • range
  • cal_constant_xpol
  • cold_noise_xpol
  • mean_doppler_velocity_xpol
  • hot_noise_copol
  • cal_constant_copol
  • hot_noise_xpol
more

Close this window