| Subject: | ASI/MFR/M1 - Connector Problem |
| DataStreams: | asimfr10mM1.a0, asimfr10mM1.b1, asimfr10mM1.00
|
| Description: | When the instrument cable was attached a pin was bent completely over that caused a host
of issues with the data. Do not use any of the data covered by this DQR. |
| Suggestions: | |
| Measurements: | asimfr10mM1.00: - Raw data stream - documentation not supported
more
asimfr10mM1.a0: - up_hemisp_narrowband_filter5
- up_hemisp_narrowband_filter6
- up_hemisp_narrowband_filter3
- up_hemisp_narrowband_filter4
- up_hemisp_narrowband_filter2_raw
- up_hemisp_narrowband_filter6_raw
- up_hemisp_narrowband_filter3_raw
- head_temp2
- up_hemisp_narrowband_filter4_raw
- up_hemisp_broadband
- head_temp
- up_hemisp_broadband_raw
- up_hemisp_narrowband_filter1_raw
- up_hemisp_narrowband_filter1
- up_hemisp_narrowband_filter5_raw
- up_hemisp_narrowband_filter2
more
asimfr10mM1.b1: - up_hemisp_narrowband_filter1
- up_hemisp_narrowband_filter2
- head_temp
- up_hemisp_broadband
- head_temp2
- up_hemisp_narrowband_filter3
- up_hemisp_narrowband_filter4
- up_hemisp_narrowband_filter5
- up_hemisp_narrowband_filter6
more
|