DQRID : D120828.6
Start DateStart TimeEnd DateEnd Time Data Quality Metric
01/06/20110000Open Ended0000Suspect
more
Subject:
SGP/KAZR/C1 - General Quality Statement
DataStreams:sgpkazrauxC1.a0, sgpkazrspeccmaskgecopolC1.a0, sgpkazrspeccmaskmdcopolC1.a0,
sgpkazrgeC1.a1, sgpkazrspeccmaskmdxpolC1.a0, sgpkazrspeccmaskgexpolC1.a0,
sgpkazrspeccmaskhicopolC1.a0, sgpkazrhiC1.a1, sgpkazrmdC1.a1, sgpkazrspeccmaskhixpolC1.a0
Description:
The KAZR continues to undergo evaluation by the radar instrument mentors, ProSensing, VAP 
developers, DQ Office, site scientists, users, etc.  As more in-depth analysis and 
calibration studies take place, we anticipate that new insights will be gained to increase the 
quality of the data and decrease the uncertainty of the measurements.  This is a 
continuous improvement process and issues will be addressed as they are discovered.

Calibration is very important.  With the addition of Ka-SACRs adjacent to the KAZRs, this 
will give us an unprecedented method of doing calibration comparisons.  The Ka-SACR will 
be able to use an external calibration target to include those components that are not 
calibrated by internal circuits.  We will not be able to point the KAZR at a calibration 
target but by comparing radar returns to the Ka-SACR, we will be able to achieve a higher 
degree of calibration than we ever could with the KAZR operating standalone as its 
predecessor, the MMCR, did.

As issues are discovered, attempts will be made to correct data that is currently in the 
Archive.  However, retrospective correction of errors due calibration, signal processing, 
component degradation and software bugs may not be possible for many of the data files.

This open-ended DQR is an advisory that some aspects of the data quality are not yet 
known.  It is also a request for users that find issues or questions with the data to contact 
the ARM Radar Engineering & Operations Group Manager, Kevin Widener, at 
kevin.widener@pnnl.gov as these issues occur so that they can be investigated and corrected if necessary.
Suggestions: 
Measurements:sgpkazrspeccmaskmdxpolC1.a0:
  • spectra
  • locator_mask
  • lat
  • velocity_bins
  • lon
  • time_offset
  • alt
  • range
  • base_time
  • time
more
sgpkazrspeccmaskhicopolC1.a0:
  • lat
  • locator_mask
  • time_offset
  • alt
  • signal_to_noise_ratio
  • time
  • mean_doppler_velocity
  • reflectivity
  • spectral_width
  • velocity_bins
  • base_time
  • range
  • lon
  • spectra
more
sgpkazrgeC1.a1:
  • lon
  • mean_doppler_velocity_copol
  • base_time
  • time_offset
  • hot_noise_xpol
  • spectral_width_copol
  • spectral_width_xpol
  • mean_doppler_velocity_xpol
  • rx_noise
  • range
  • reflectivity_copol
  • cal_constant_copol
  • signal_to_noise_ratio_xpol
  • cal_constant_xpol
  • sky_noise_copol
  • cold_noise_copol
  • signal_to_noise_ratio_copol
  • time
  • cold_noise_xpol
  • lat
  • reflectivity_xpol
  • sky_noise_xpol
  • alt
  • hot_noise_copol
more
sgpkazrspeccmaskgecopolC1.a0:
  • time
  • lon
  • mean_doppler_velocity
  • alt
  • lat
  • locator_mask
  • time_offset
  • signal_to_noise_ratio
  • spectral_width
  • velocity_bins
  • spectra
  • base_time
  • range
  • reflectivity
more
sgpkazrspeccmaskhixpolC1.a0:
  • velocity_bins
  • spectral_width
  • lon
  • signal_to_noise_ratio
  • base_time
  • mean_doppler_velocity
  • time_offset
  • time
  • spectra
  • reflectivity
  • range
  • lat
  • alt
  • locator_mask
more
sgpkazrspeccmaskgexpolC1.a0:
  • time
  • alt
  • lat
  • locator_mask
  • signal_to_noise_ratio
  • lon
  • base_time
  • time_offset
  • spectral_width
  • mean_doppler_velocity
  • spectra
  • reflectivity
  • range
  • velocity_bins
more
sgpkazrauxC1.a0:
  • input_12V
  • cal_constant_ch1_xpol
  • time_offset
  • temp_lna
  • cal_constant_ch2_copol
  • power_supply_28V
  • twta_status_is_valid
  • tx_power
  • power_supply_5p2V
  • power_supply_5V
  • lock_alarm_1620
  • temp_component_plate
  • input_5V
  • temp_noise_diode
  • fault_flags
  • input_15V
  • temp_reverse_power
  • temp_local
  • processing_mode
  • lon
  • fft_taper_type
  • temp_antenna_feedhorn
  • helix_current
  • lock_alarm_16560
  • temp_rf_detector
  • noise_source_ch2
  • noise_source_ch1
  • cathode_voltage
  • rx_gain_ch1
  • rx_gain_ch2
  • remote_control_enabled
  • time
  • input_8V
  • temp_power_supply
  • base_time
  • collector_voltage
  • temp_outside_air
  • timing_mode
  • rh_local
  • cal_constant_ch2_xpol
  • twta_latest_fault_time_epoch
  • input_minus5V
  • alt
  • lat
  • cal_constant_ch1_copol
  • filament_voltage
  • rh_antenna
  • is_powered_on
  • lock_alarm_120
  • lock_alarm_360
  • rx_noise_ch2
  • rx_noise_ch1
  • temp_antenna
  • temp_circulator
  • twta_status_state
more
sgpkazrmdC1.a1:
  • reflectivity_xpol
  • reflectivity_copol
  • spectral_width_xpol
  • rx_noise
  • cold_noise_xpol
  • time
  • base_time
  • time_offset
  • hot_noise_xpol
  • cal_constant_copol
  • mean_doppler_velocity_xpol
  • sky_noise_xpol
  • lat
  • hot_noise_copol
  • cold_noise_copol
  • alt
  • cal_constant_xpol
  • mean_doppler_velocity_copol
  • sky_noise_copol
  • signal_to_noise_ratio_xpol
  • lon
  • spectral_width_copol
  • range
  • signal_to_noise_ratio_copol
more
sgpkazrhiC1.a1:
  • sky_noise_copol
  • reflectivity_xpol
  • reflectivity_copol
  • spectral_width_copol
  • rx_noise
  • alt
  • lat
  • signal_to_noise_ratio_copol
  • base_time
  • lon
  • mean_doppler_velocity_copol
  • sky_noise_xpol
  • signal_to_noise_ratio_xpol
  • spectral_width_xpol
  • time
  • time_offset
  • cold_noise_copol
  • range
  • cal_constant_xpol
  • cold_noise_xpol
  • mean_doppler_velocity_xpol
  • hot_noise_copol
  • cal_constant_copol
  • hot_noise_xpol
more
sgpkazrspeccmaskmdcopolC1.a0:
  • locator_mask
  • spectra
  • base_time
  • velocity_bins
  • time
  • alt
  • lat
  • time_offset
  • lon
  • range
more

Close this window