DQRID : D120828.7
Start DateStart TimeEnd DateEnd Time Data Quality Metric
05/12/20110000Open Ended0000Suspect
more
Subject:
NSA/KAZR/C1 - General Quality Statement
DataStreams:nsakazrspeccmaskhicopolC1.a0, nsakazrspeccmaskgecopolC1.a0, nsakazrspeccmaskmdcopolC1.a0,
nsakazrspeccmaskhixpolC1.a0, nsakazrspeccmaskmdxpolC1.a0, nsakazrmdC1.a1,
nsakazrhiC1.a1, nsakazrspeccmaskgexpolC1.a0, nsakazrauxC1.a0, nsakazrgeC1.a1
Description:
The KAZR continues to undergo evaluation by the radar instrument mentors, ProSensing, VAP 
developers, DQ Office, site scientists, users, etc.  As more in-depth analysis and 
calibration studies take place, we anticipate that new insights will be gained to increase the 
quality of the data and decrease the uncertainty of the measurements.  This is a 
continuous improvement process and issues will be addressed as they are discovered.

Calibration is very important.  With the addition of Ka-SACRs adjacent to the KAZRs, this 
will give us an unprecedented method of doing calibration comparisons.  The Ka-SACR will 
be able to use an external calibration target to include those components that are not 
calibrated by internal circuits.  We will not be able to point the KAZR at a calibration 
target but by comparing radar returns to the Ka-SACR, we will be able to achieve a higher 
degree of calibration than we ever could with the KAZR operating standalone as its 
predecessor, the MMCR, did.

As issues are discovered, attempts will be made to correct data that is currently in the 
Archive.  However, retrospective correction of errors due calibration, signal processing, 
component degradation and software bugs may not be possible for many of the data files.

This open-ended DQR is an advisory that some aspects of the data quality are not yet 
known.  It is also a request for users that find issues or questions with the data to contact 
the ARM Radar Engineering & Operations Group Manager, Kevin Widener, at 
kevin.widener@pnnl.gov as these issues occur so that they can be investigated and corrected if necessary.
Suggestions: 
Measurements:nsakazrgeC1.a1:
  • mean_doppler_velocity_xpol
  • cal_constant_copol
  • spectral_width_xpol
  • mean_doppler_velocity_copol
  • lon
  • hot_noise_copol
  • reflectivity_xpol
  • spectral_width_copol
  • time
  • alt
  • lat
  • reflectivity_copol
  • signal_to_noise_ratio_copol
  • rx_noise
  • cal_constant_xpol
  • signal_to_noise_ratio_xpol
  • hot_noise_xpol
  • time_offset
  • range
  • cold_noise_xpol
  • sky_noise_xpol
  • sky_noise_copol
  • cold_noise_copol
  • base_time
more
nsakazrspeccmaskmdcopolC1.a0:
  • time_offset
  • reflectivity
  • mean_doppler_velocity
  • spectral_width
  • range
  • time
  • locator_mask
  • spectra
  • velocity_bins
  • signal_to_noise_ratio
  • base_time
more
nsakazrauxC1.a0:
  • temp_circulator
  • temp_noise_diode
  • time
  • time_offset
  • lon
  • rh_local
  • cal_constant_ch2_copol
  • fft_taper_type
  • temp_power_supply
  • helix_current
  • power_supply_28V
  • temp_reverse_power
  • rh_antenna
  • alt
  • cal_constant_ch1_copol
  • twta_status_is_valid
  • cal_constant_ch1_xpol
  • input_8V
  • cathode_voltage
  • lock_alarm_120
  • power_supply_5V
  • lock_alarm_360
  • fault_flags
  • tx_power
  • input_12V
  • lat
  • filament_voltage
  • cal_constant_ch2_xpol
  • processing_mode
  • temp_lna
  • power_supply_5p2V
  • lock_alarm_16560
  • temp_component_plate
  • input_15V
  • input_5V
  • temp_antenna_feedhorn
  • input_minus5V
  • rx_gain_ch1
  • twta_latest_fault_time_epoch
  • rx_gain_ch2
  • temp_antenna
  • rx_noise_ch2
  • rx_noise_ch1
  • remote_control_enabled
  • collector_voltage
  • is_powered_on
  • base_time
  • lock_alarm_1620
  • temp_local
  • temp_rf_detector
  • temp_outside_air
  • timing_mode
  • twta_status_state
  • noise_source_ch2
  • noise_source_ch1
more
nsakazrhiC1.a1:
  • cold_noise_xpol
  • sky_noise_xpol
  • hot_noise_copol
  • signal_to_noise_ratio_copol
  • signal_to_noise_ratio_xpol
  • range
  • cold_noise_copol
  • time_offset
  • lon
  • time
  • rx_noise
  • spectral_width_copol
  • reflectivity_copol
  • spectral_width_xpol
  • base_time
  • cal_constant_xpol
  • hot_noise_xpol
  • mean_doppler_velocity_copol
  • lat
  • mean_doppler_velocity_xpol
  • alt
  • sky_noise_copol
  • cal_constant_copol
  • reflectivity_xpol
more
nsakazrspeccmaskhixpolC1.a0:
  • locator_mask
  • spectra
  • signal_to_noise_ratio
  • velocity_bins
  • range
  • reflectivity
  • time
  • mean_doppler_velocity
  • time_offset
  • base_time
  • spectral_width
more
nsakazrspeccmaskhicopolC1.a0:
  • reflectivity
  • spectra
  • base_time
  • time
  • time_offset
  • range
  • spectral_width
  • lon
  • velocity_bins
  • signal_to_noise_ratio
  • mean_doppler_velocity
  • locator_mask
  • lat
  • alt
more
nsakazrmdC1.a1:
  • sky_noise_copol
  • mean_doppler_velocity_copol
  • time
  • mean_doppler_velocity_xpol
  • time_offset
  • lat
  • alt
  • base_time
  • signal_to_noise_ratio_copol
  • hot_noise_xpol
  • sky_noise_xpol
  • lon
  • cold_noise_xpol
  • cal_constant_xpol
  • hot_noise_copol
  • cal_constant_copol
  • range
  • reflectivity_copol
  • reflectivity_xpol
  • rx_noise
  • spectral_width_xpol
  • spectral_width_copol
  • signal_to_noise_ratio_xpol
  • cold_noise_copol
more
nsakazrspeccmaskmdxpolC1.a0:
  • base_time
  • time_offset
  • mean_doppler_velocity
  • spectral_width
  • range
  • time
  • spectra
  • velocity_bins
  • locator_mask
  • signal_to_noise_ratio
  • reflectivity
more
nsakazrspeccmaskgexpolC1.a0:
  • spectra
  • time_offset
  • mean_doppler_velocity
  • range
  • signal_to_noise_ratio
  • locator_mask
  • time
  • reflectivity
  • base_time
  • spectral_width
  • velocity_bins
more
nsakazrspeccmaskgecopolC1.a0:
  • reflectivity
  • time_offset
  • spectral_width
  • range
  • mean_doppler_velocity
  • locator_mask
  • signal_to_noise_ratio
  • time
  • base_time
  • spectra
  • velocity_bins
more

Close this window