SGP/EBBR/E8 - E8 EBBR AEM Stuck In One Position

When the AEM (automatic exchange mechanism) is stuck in one postion, 
half hour latent and sensible heat fluxes and the Bowen ratio
are incorrect.  Some of the raw EBBR measurements are also incorrect. 

I do not normally submit a DQR for this situation, as the qc checks for
AEM home signals normally indicate the problem.  However, the frequency
of the problem at this site seems to warrant DQRs.

• Top T/RH sensor temperature(temp_trh_top)
• Bottom air temperature(temp_air_bottom)
• Bottom relative humidity (fractional)(rh_bottom_fraction)
• Bottom T/RH sensor temperature(temp_trh_bottom)
• Bottom vapor pressure(vapor_pressure_bottom)
• Top relative humidity (fractional)(rh_top_fraction)
• Top vapor pressure(vapor_pressure_top)
• Top air temperature(temp_air_top)

• Right air temperature(temp_air_right)
• Left air temperature(temp_air_left)
• Left T/RH sensor temperature (resistance ratio)(temp_trh_left_rr)
• Right relative humidity (mV)(rh_right_mv)
• Left relative humidity (mV)(rh_left_mv)
• Right T/RH sensor temperature (resistance ratio)(temp_trh_right_rr)

• Bottom vapor pressure(vapor_pressure_bottom)
• Surface latent heat flux(latent_heat_flux)
• Bottom air temperature(temp_air_bottom)
• Bottom T/RH sensor temperature(temp_trh_bottom)
• Bottom relative humidity (fractional)(rh_bottom_fraction)
• Surface sensible heat flux(sensible_heat_flux)
• Top relative humidity (fractional)(rh_top_fraction)
• Top vapor pressure(vapor_pressure_top)
• Bowen ratio(bowen_ratio)
• Top T/RH sensor temperature(temp_trh_top)
• Top air temperature(temp_air_top)