NSA/KAZR/C1 - PLO Failure

Streaks began showing up in radar data (reflectivity, doppler velocity, spectral width, 
SNR) at semi regular intervals.  Problem was a failed 16.560 GHz Phase Lock Oscillator 
(PLO).  PLO was replaced 20120214.

Data should be used for qualitative purposes only due to the "streakiness" in the data..

• Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
• Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
• Signal to noise ratio, cross-polarization(signal_to_noise_ratio_xpol)
• Spectral width, cross-polarization(spectral_width_xpol)
• Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
• Reflectivity, cross-polar(reflectivity_xpol)
• Spectral width, co-polarization(spectral_width_copol)
• Reflectivity, copolar(reflectivity_copol)

• LNA temperature(temp_lna)
• +5.2 V power supply voltage on radar control board(power_supply_5p2V)
• 4-port circulator temperature(temp_circulator)
• Lock alarms for 16560 MHz oscillator.(lock_alarm_16560)
• Component plate temperature(temp_component_plate)
• Physical temperature of noise diode(temp_noise_diode)
• time_in_seconds_since_volume_start(time)
• Time offset from base_time(time_offset)
• lon(lon)
• Relative humidity measured by sensor on radar control board(rh_local)
• Radar calibration constant, channel 2, copolar(cal_constant_ch2_copol)
• Taper factor added to fast fourier transform.(fft_taper_type)
• +15 V power supply voltage(input_15V)
• +5 V power supply voltage(input_5V)
• DC power supply temperature(temp_power_supply)
• Antenna feedhorn temperature(temp_antenna_feedhorn)
• -5 V power supply voltage(input_minus5V)
• Current reported by the TWTA helix.(helix_current)
• Receiver gain, channel 1(rx_gain_ch1)
• Receiver gain, channel 2(rx_gain_ch2)
• Time of last detected TWTA fault.(twta_latest_fault_time_epoch)
• +28 V power supply voltage on radar control board(power_supply_28V)
• Antenna temperature(temp_antenna)
• Reverse power termination temperature(temp_reverse_power)
• Receiver noise, channel 2(rx_noise_ch2)
• Receiver noise, channel 1(rx_noise_ch1)
• Antenna relative humidity(rh_antenna)
• Remote control enabled (0/1)(remote_control_enabled)
• -180.0 - +180.0(alt)
• Voltage reported by the TWTA collector.(collector_voltage)
• On/Off state(is_powered_on)
• Radar calibration constant, channel 1, copolar(cal_constant_ch1_copol)
• base time in epoch(base_time)
• Status of the TWTA monitored values.(twta_status_is_valid)
• Radar calibration constant, channel 1, cross-polar(cal_constant_ch1_xpol)
• +8 V power supply voltage(input_8V)
• Voltage reported by the TWTA cathode.(cathode_voltage)
• Lock alarms for 120 MHz oscillator.(lock_alarm_120)
• +5 V power supply voltage on radar control board(power_supply_5V)
• Lock alarms for 360 MHz oscillator.(lock_alarm_360)
• Lock alarms for 1620 MHz oscillator.(lock_alarm_1620)
• Instrument fault flags(fault_flags)
• Temperature measured by sensor on radar control board(temp_local)
• RF detector temperature(temp_rf_detector)
• Outside air temperature(temp_outside_air)
• KAZR timing mode(timing_mode)
• Transmit power(tx_power)
• +12 V power supply voltage(input_12V)
• TWTA status state(twta_status_state)
• North Latitude(lat)
• Heater filament voltage, inside the TWTA.(filament_voltage)
• Radar calibration constant, channel 2, cross-polar(cal_constant_ch2_xpol)
• KAZR processing mode(processing_mode)
• Noise source, channel 2(noise_source_ch2)
• Noise source, channel 1(noise_source_ch1)

• reflectivity(reflectivity)
• Mean doppler velocity(mean_doppler_velocity)
• Signal-to-noise ratio(signal_to_noise_ratio)
• Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)

• Spectral width, co-polarization(spectral_width_copol)
• Reflectivity, copolar(reflectivity_copol)
• Spectral width, cross-polarization(spectral_width_xpol)
• Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
• Signal to noise ratio, cross-polarization(signal_to_noise_ratio_xpol)
• Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
• Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
• Reflectivity, cross-polar(reflectivity_xpol)

• Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)
• reflectivity(reflectivity)
• Signal-to-noise ratio(signal_to_noise_ratio)
• Mean doppler velocity(mean_doppler_velocity)

• Signal-to-noise ratio(signal_to_noise_ratio)
• Mean doppler velocity(mean_doppler_velocity)
• reflectivity(reflectivity)
• Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)

• Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
• Reflectivity, copolar(reflectivity_copol)
• Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
• Reflectivity, cross-polar(reflectivity_xpol)
• Spectral width, cross-polarization(spectral_width_xpol)
• Spectral width, co-polarization(spectral_width_copol)
• Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
• Signal to noise ratio, cross-polarization(signal_to_noise_ratio_xpol)

• Signal-to-noise ratio(signal_to_noise_ratio)
• Mean doppler velocity(mean_doppler_velocity)
• reflectivity(reflectivity)
• Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)

• Mean doppler velocity(mean_doppler_velocity)
• reflectivity(reflectivity)
• Signal-to-noise ratio(signal_to_noise_ratio)
• Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)

• reflectivity(reflectivity)
• Signal-to-noise ratio(signal_to_noise_ratio)
• Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)
• Mean doppler velocity(mean_doppler_velocity)