Description: | See below for details of reprocessing that was completed on 20150626. Original
DQR category: 4 (Red, Incorrect).
-----------------------------------------------------------
The MPL was on standard time, not UTC, and the problem went uncorrected until 20131130.
Data have a one hour time offset. Data marked with timestamp 000000 should be corrected
to reflect the actual UTC time of 010000. |
Measurements: | enamplpolfsC1.b1: - Time offset from base_time(time_offset)
- Polarization control voltage setting(polarization_control_voltage)
- Time in nanoseconds for each range bin of multichannel scalar card.(range_bin_time)
- Background signal, cross pol data(background_signal_cross_pol)
- base time in epoch(base_time)
- Bin number of first data. Tells where pretrigger timing ends and end of region
for background data sampling laser_fire_bin(first_data_bin) - Attenuated backscatter, co-pol(signal_return_co_pol)
- time_in_seconds_since_volume_start(time)
- Laser output energy per pulse(energy_monitor)
- Subtract from range_bins to yield range(range_offset)
- Detector Temperature(detector_temp)
- Dead time correction flag(dead_time_corrected)
- Background signal, co-pol(background_signal_co_pol)
- Polarization control enabled flag(polarization_control)
- Laser Temperature(laser_temp)
- Attenuated backscatter, cross pol(signal_return_cross_pol)
- Laboratory measured counts used to calculate the deadtime correction samples(deadtime_correction_counts)
- Width of range-bins calculated from range_bin_time(range_bin_width)
- Deadtime correction factor(deadtime_correction)
- Background signal standard deviation, cross-pol(background_signal_std_cross_pol)
- Preliminary cloud base height above ground level(preliminary_cbh)
- Background signal standard deviation, copol data(background_signal_std_co_pol)
- Telescope temperature(scope_temp)
more
|