Measurements: | magmplpolfsM1.b1: - Laser output energy per pulse(energy_monitor)
- Background signal, co-pol(background_signal_co_pol)
- North Latitude(lat)
- time_in_seconds_since_volume_start(time)
- Repetition Rate, or Trigger Frequency of the laser(pulse_rep)
- Background signal standard deviation, cross-pol(background_signal_std_cross_pol)
- Quality check results on field: Attenuated backscatter, cross pol(qc_signal_return_cross_pol)
- base time in epoch(base_time)
- Laser Temperature(laser_temp)
- Attenuated backscatter, cross pol(signal_return_cross_pol)
- Maximum altitude retrieved from multichannel scalar card.(max_altitude)
- Polarization control voltage setting(polarization_control_voltage)
- Polarization control enabled flag(polarization_control)
- Preliminary cloud base height above ground level(preliminary_cbh)
- Quality check results on field: Telescope temperature(qc_scope_temp)
- Number of bins stored in data block(num_bins)
- Laboratory measured counts used to calculate the deadtime correction samples(deadtime_correction_counts)
- Background signal, cross pol data(background_signal_cross_pol)
- Telescope temperature(scope_temp)
- Deadtime correction factor(deadtime_correction)
- Subtract from range_bins to yield range(range_offset)
- Results of quality checks on sample time(qc_time)
- Distance to the center of the corresponding range bin(range)
- lon(lon)
- Quality check results on field: Detector temperature(qc_detector_temp)
- Quality check results on field: Distance between initial range_bin and the laser
flash(qc_range_offset) - Number of detector channels(num_channels)
- MCS mode register, value is either 167 or 199.(mcs_mode)
- Attenuated backscatter, co-pol(signal_return_co_pol)
- Overlap correction(overlap_correction)
- Quality check results on field: Attenuated backscatter, copol(qc_signal_return_co_pol)
- Time offset from base_time(time_offset)
- Dead time correction flag(dead_time_corrected)
- Quality check results on field: Preliminary cloud base height above ground level(qc_preliminary_cbh)
- Height(height)
- Quality check results on field: Laser temperature(qc_laser_temp)
- -180.0 - +180.0(alt)
- Detector Temperature(detector_temp)
- Quality check results on field: Energy output per pulse of transmitted laser
beam at 532 nm (Doubled Nd-YLF)(qc_energy_monitor) - Bin number of first data. Tells where pretrigger timing ends and end of region
for background data sampling laser_fire_bin(first_data_bin) - Heights for overlap correction(overlap_correction_heights)
- Background signal standard deviation, copol data(background_signal_std_co_pol)
- Time in nanoseconds for each range bin of multichannel scalar card.(range_bin_time)
- Distance from leading edge of first range bin to the center of each bin .(range_bins)
- Width of range-bins calculated from range_bin_time(range_bin_width)
more
|