Measurements: | acxkazrauxM1.a0: - Status of the TWTA monitored values.(twta_status_is_valid)
- Voltage reported by the TWTA collector.(collector_voltage)
- On/Off state(is_powered_on)
- Current reported by the TWTA helix.(helix_current)
- Outside air temperature(temp_outside_air)
- Radar calibration constant, channel 1, cross-polar(cal_constant_ch1_xpol)
- -5 V power supply voltage(input_minus5V)
- +28 V power supply voltage on radar control board(power_supply_28V)
- Radar calibration constant, channel 2, copolar(cal_constant_ch2_copol)
- +8 V power supply voltage(input_8V)
- Receiver gain, channel 2(rx_gain_ch2)
- Receiver gain, channel 1(rx_gain_ch1)
- Physical temperature of noise diode(temp_noise_diode)
- 4-port circulator temperature(temp_circulator)
- DC power supply temperature(temp_power_supply)
- Radar calibration constant, channel 2, cross-polar(cal_constant_ch2_xpol)
- PDU status j1 logic ... need description(pdu_status_j1_logic)
- KAZR timing mode(timing_mode)
- -180.0 - +180.0(alt)
- Transmit power(tx_power)
- Antenna relative humidity(rh_antenna)
- Radar calibration constant, channel 1, copolar(cal_constant_ch1_copol)
- North Latitude(lat)
- Instrument fault flags(fault_flags)
- j2 logic ... need description(j2_logic)
- Time offset from base_time(time_offset)
- Taper factor added to fast fourier transform.(fft_taper_type)
- +5 V power supply voltage on radar control board(power_supply_5V)
- Component plate temperature(temp_component_plate)
- +5.2 V power supply voltage on radar control board(power_supply_5p2V)
- Noise source, channel 1(noise_source_ch1)
- Noise source, channel 2(noise_source_ch2)
- Remote control enabled (0/1)(remote_control_enabled)
- Lock alarms for 1620 MHz oscillator.(lock_alarm_1620)
- Lock alarms for 360 MHz oscillator.(lock_alarm_360)
- TWTA status state(twta_status_state)
- Temperature measured by sensor on radar control board(temp_local)
- Lock alarms for 120 MHz oscillator.(lock_alarm_120)
- RF detector temperature(temp_rf_detector)
- +15 V power supply voltage(input_15V)
- Lock alarms for 16560 MHz oscillator.(lock_alarm_16560)
- lon(lon)
- Time of last detected TWTA fault.(twta_latest_fault_time_epoch)
- Antenna temperature(temp_antenna)
- spare analog ... need a list of possible values(spare_analog_j12_1)
- Receiver noise, channel 2(rx_noise_ch2)
- Voltage reported by the TWTA cathode.(cathode_voltage)
- Receiver noise, channel 1(rx_noise_ch1)
- KAZR processing mode(processing_mode)
- Heater filament voltage, inside the TWTA.(filament_voltage)
- +12 V power supply voltage(input_12V)
- Relative humidity measured by sensor on radar control board(rh_local)
- time_in_seconds_since_volume_start(time)
- Reverse power termination temperature(temp_reverse_power)
- LNA temperature(temp_lna)
- Antenna feedhorn temperature(temp_antenna_feedhorn)
- +5 V power supply voltage(input_5V)
- base time in epoch(base_time)
more
acxkazrgeM1.b1: - Distance to the center of the corresponding range bin(range)
- Receiver noise(rx_noise)
- Reflectivity, cross-polar(reflectivity_xpol)
- Reflectivity, copolar(reflectivity_copol)
- Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
- Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
- Time offset from base_time(time_offset)
- Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
- Radar calibration constant, cross-polar(cal_constant_xpol)
- Radar calibration constant, copolar(cal_constant_copol)
- Spectral width, cross-polarization(spectral_width_xpol)
- Signal to noise ratio, cross-polarization(signal_to_noise_ratio_xpol)
- Spectral width, co-polarization(spectral_width_copol)
- time_in_seconds_since_volume_start(time)
- base time in epoch(base_time)
- Results of quality checks on sample time(qc_time)
more
acxkazrhiM1.a1: - Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
- North Latitude(lat)
- time_in_seconds_since_volume_start(time)
- Receiver noise(rx_noise)
- Cold noise, copolar(cold_noise_copol)
- base time in epoch(base_time)
- Distance to the center of the corresponding range bin(range)
- -180.0 - +180.0(alt)
- Radar calibration constant, copolar(cal_constant_copol)
- Spectral width, co-polarization(spectral_width_copol)
- Reflectivity, copolar(reflectivity_copol)
- Sky noise, copolar(sky_noise_copol)
- Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
- lon(lon)
- Hot noise, co-polarization(hot_noise_copol)
- Time offset from base_time(time_offset)
more
acxkazrspeccmaskhicopolM1.a0: - lon(lon)
- Spectra(spectra)
- base time in epoch(base_time)
- Locator Mask for Spectra(locator_mask)
- Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)
- Mean doppler velocity(mean_doppler_velocity)
- Spectral velocity bins(velocity_bins)
- Signal-to-noise ratio(signal_to_noise_ratio)
- reflectivity(reflectivity)
- -180.0 - +180.0(alt)
- North Latitude(lat)
- Distance to the center of the corresponding range bin(range)
- time_in_seconds_since_volume_start(time)
- Time offset from base_time(time_offset)
more
acxkazrmdM1.a1: - Radar calibration constant, cross-polar(cal_constant_xpol)
- Cold noise, copolar(cold_noise_copol)
- time_in_seconds_since_volume_start(time)
- Reflectivity, copolar(reflectivity_copol)
- lon(lon)
- Spectral width, co-polarization(spectral_width_copol)
- Signal to noise ratio, cross-polarization(signal_to_noise_ratio_xpol)
- North Latitude(lat)
- Cold noise, cross-polarization(cold_noise_xpol)
- -180.0 - +180.0(alt)
- Hot noise, co-polarization(hot_noise_copol)
- Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
- Spectral width, cross-polarization(spectral_width_xpol)
- base time in epoch(base_time)
- Receiver noise(rx_noise)
- Hot noise, cross-polar(hot_noise_xpol)
- Radar calibration constant, copolar(cal_constant_copol)
- Reflectivity, cross-polar(reflectivity_xpol)
- Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
- Sky noise, copolar(sky_noise_copol)
- Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
- Time offset from base_time(time_offset)
- Distance to the center of the corresponding range bin(range)
- Sky noise, cross-polarization(sky_noise_xpol)
more
acxkazrspeccmaskgecopolM1.a0: - Distance to the center of the corresponding range bin(range)
- Spectral velocity bins(velocity_bins)
- reflectivity(reflectivity)
- Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)
- time_in_seconds_since_volume_start(time)
- Locator Mask for Spectra(locator_mask)
- Time offset from base_time(time_offset)
- Mean doppler velocity(mean_doppler_velocity)
- base time in epoch(base_time)
- Signal-to-noise ratio(signal_to_noise_ratio)
- Spectra(spectra)
more
acxkazrspeccmaskmdcopolM1.a0: - Distance to the center of the corresponding range bin(range)
- Signal-to-noise ratio(signal_to_noise_ratio)
- Spectral velocity bins(velocity_bins)
- Spectra(spectra)
- Time offset from base_time(time_offset)
- Mean doppler velocity(mean_doppler_velocity)
- Locator Mask for Spectra(locator_mask)
- base time in epoch(base_time)
- time_in_seconds_since_volume_start(time)
- Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)
- reflectivity(reflectivity)
more
acxkazrgeM1.a1: - Cold noise, copolar(cold_noise_copol)
- Reflectivity, copolar(reflectivity_copol)
- time_in_seconds_since_volume_start(time)
- Distance to the center of the corresponding range bin(range)
- -180.0 - +180.0(alt)
- Sky noise, copolar(sky_noise_copol)
- Spectral width, co-polarization(spectral_width_copol)
- lon(lon)
- Time offset from base_time(time_offset)
- Radar calibration constant, copolar(cal_constant_copol)
- Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
- North Latitude(lat)
- Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
- Hot noise, co-polarization(hot_noise_copol)
- base time in epoch(base_time)
- Receiver noise(rx_noise)
more
|