Subject: | ACX/HTDMA/M1 - Failure to fill butanol into HTDMA |
DataStreams: | acxaoshtdmaM1.a1, acxaoshtdmaM1.00
|
Description: | CPC counts went to zero and remained at zero until the end of the stated time range. The
CPC was on and detecting only shot noise from the optical detector. Indications suggest
that butanol was not being filled into the HT-DMA |
Suggestions: | Do not use data |
Measurements: | acxaoshtdmaM1.a1: - Bin center value(bin_center)
- Maximum aerosol particle diameter instrument setting(scan_max_diameter_setting)
- Dry aerosol diameter size instrument setting(dry_diameter_setting)
- Dry aerosol particle relative humidity instrument setting(dry_rh_setting)
- Bin width(bin_width)
- Concentration of aerosol(aerosol_concentration)
- Sample flow rate(sample_flow)
- Minimum aerosol particle diameter instrument setting(scan_min_diameter_setting)
- Atomizer calibration status(atomizer)
- Humid aerosol particle relative humidity(humid_rh)
- Humidified DMA scanning time instrument setting(scan_time_setting)
- Total scan concentration over all bins(total_concentration)
- Number of bins stored in data block(num_bins)
- Bin numbers for sweep measurements(bin)
- Sampling mode scan type(scan_type)
more
acxaoshtdmaM1.00: - (Raw data stream - documentation not supported)
more
|