| Subject: | MAO/WACR/M1 - Transmitter failure |
| DataStreams: | maowacrspeccmaskcopolM1.a0, maowacrM1.a1, maowacrM1.00, maowacrspeccmaskxpolM1.a0
|
| Description: | Transmitter went down during this period. |
| Suggestions: | Do not use data |
| Measurements: | maowacrspeccmaskxpolM1.a0: - Transmit driver power sampled by receiver(PowerTransmitDriver)
- status flag(wacr_status)
- Ambient load power(PowerAmbientLoad)
- Hot load power(PowerHotLoad)
- Detected Pulse(txpower)
- Spectra(Spectra)
- MMCR Spectral Width(SpectralWidth)
- Spectral velocity bins(velocity_bins)
- Reflectivity(Reflectivity)
- Locator Mask for Spectra(LocatorMask)
- MMCR Mean Doppler Velocity(MeanDopplerVelocity)
- Signal to Noise Ratio(SignalToNoiseRatio)
- Calculated Noise(Noise)
more
maowacrspeccmaskcopolM1.a0: - Locator Mask for Spectra(LocatorMask)
- Detected Pulse(txpower)
- Signal to Noise Ratio(SignalToNoiseRatio)
- Calculated Noise(Noise)
- Ambient load power(PowerAmbientLoad)
- MMCR Spectral Width(SpectralWidth)
- Hot load power(PowerHotLoad)
- Reflectivity(Reflectivity)
- status flag(wacr_status)
- Spectra(Spectra)
- MMCR Mean Doppler Velocity(MeanDopplerVelocity)
- Transmit driver power sampled by receiver(PowerTransmitDriver)
- Spectral velocity bins(velocity_bins)
more
maowacrM1.a1: - Signal-to-noise ratio(signal_to_noise_ratio)
- Receiver noise figure estimated from noise source measurements using Y-factor
method(noise_figure) - reflectivity(reflectivity)
- Mean doppler velocity(mean_doppler_velocity)
- Doppler spectrum width (second moment of the doppler spectrum)(spectral_width)
- Total sky noise power prior to spectrum computation(noise_power_sky)
- Receiver gain estimated from noise source measurements using Y-factor method(gain)
- Polarization mode.(polarization)
more
maowacrM1.00: - (Raw data stream - documentation not supported)
more
|