Subject: | MAO/SMPS/S1 - Data not available |
DataStreams: | maoaossmpstrhS1.a1, maoaossmpsS1.a1
|
Description: | The SMPS was being used as a calibration device for the calibration of the ACSM during
these periods and no samples were taken. |
Suggestions: | No Data available during these periods |
Measurements: | maoaossmpstrhS1.a1: - -180.0 - +180.0(alt)
- time_in_seconds_since_volume_start(time)
- North Latitude(lat)
- Sample temperature(sample_temperature)
- base time in epoch(base_time)
- lon(lon)
- Time offset from base_time(time_offset)
- Sample relative humidity(sample_rh)
more
maoaossmpsS1.a1: - Time offset from base_time(time_offset)
- lon(lon)
- Sample pressure(sample_pressure)
- Mean diameter of size distribution(mean)
- CPC sample flow rate(CPC_sample_flow)
- Aerosol flow rate(aerosol_flow)
- Lower size limit(lower_size)
- Sample temperature(sample_temperature)
- North Latitude(lat)
- time_in_seconds_since_volume_start(time)
- Mean diameter of size distribution using a geometric average(geometric_mean)
- Total scan concentration over all bins(total_concentration)
- High voltage reading(high_voltage)
- Mode index(mode)
- Standard deviation of mean diameter of size distribution using geometric average(geometric_mean_std)
- CPC inlet flow rate(CPC_inlet_flow)
- Flag indicating aeri retrieval status(status_flag)
- Median diameter of size distribution(median)
- -180.0 - +180.0(alt)
- Gas viscosity(gas_viscosity)
- Mean free path(mean_free_path)
- Low voltage reading(low_voltage)
- 50 percent cut-point diameter of the impactor(d50)
- base time in epoch(base_time)
- Number size distribution (dN/dlogDp)(number_size_distribution)
- Bins for diameter midpoint measurements(diameter_midpoint)
- Sheath flow(sheath_flow)
more
|