DQRID : D160610.7
Start DateStart TimeEnd DateEnd Time
05/30/2016170006/05/20160100
more
Subject:
AWR/KAZR/M1 - Transmit Power Low
DataStreams:awrkazrspeccmaskmdcopolM1.a0, awrkazrspecM1.00, awrkazrspeccmaskgecopolM1.a0,
awrkazrmdM1.a1, awrkazrgeM1.a1, awrkazrM1.00, awrkazrauxM1.a0, awrkazrhiM1.a1
Description:
The data look OK, but the transmit power was reported at ~25dB vs the normal 51dB.  There 
was likely a sensor error with reading the transmitter output, but be cautious when using 
the data either way.
Suggestions: 
Measurements:awrkazrmdM1.a1:  
  • Receiver noise(rx_noise)
  • Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
  • Reflectivity, copolar(reflectivity_copol)
  • Spectral width, co-polarization(spectral_width_copol)
  • Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
  • Sky noise, copolar(sky_noise_copol)
more

awrkazrspecM1.00:  
  • (Raw data stream - documentation not supported)
more

awrkazrM1.00:  
  • (Raw data stream - documentation not supported)
more

awrkazrauxM1.a0:  
  • Transmit power(tx_power)
more

awrkazrspeccmaskmdcopolM1.a0:  
  • Locator Mask for Spectra(locator_mask)
  • Spectra(spectra)
more

awrkazrspeccmaskgecopolM1.a0:  
  • Locator Mask for Spectra(locator_mask)
  • Spectra(spectra)
more

awrkazrgeM1.a1:  
  • Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
  • Reflectivity, copolar(reflectivity_copol)
  • Sky noise, copolar(sky_noise_copol)
  • Receiver noise(rx_noise)
  • Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
  • Spectral width, co-polarization(spectral_width_copol)
more

awrkazrhiM1.a1:  
  • Signal-to-noise ratio, copolar(signal_to_noise_ratio_copol)
  • Reflectivity, copolar(reflectivity_copol)
  • Mean doppler velocity, copolar, dealiased(mean_doppler_velocity_copol)
  • Spectral width, co-polarization(spectral_width_copol)
  • Sky noise, copolar(sky_noise_copol)
more


Close this window