Description: | A weighing bucket rain gauge was installed during this time frame. There was a consistent
problem with noisy in the data from the start. The 1 minute data are in the a1-level
files and the 5-minute averages are in the b1-level.
Daily accumulations calculated from the b1-level data do agree fairly well with the other
instruments onsite at times. It is recommended that a user also orders the MET,
Disdrometer, or VDIS datastreams for comparison. |
Measurements: | twprainC3.b1: - Total precipitation over one minute sampling period(precip)
- Weight of accumulated precipitation in the gauge since the la st tare(total_weight)
- Panel temperature average(ptemp)
- Total maintenance count(maintenance_cnt)
- Precipitation intensity(precip_rate)
- Sensor 2 maximum weight(weight2)
- Sensor 3 maximum weight(weight3)
- Sensor 1 maximum weight(weight1)
- Temperature 3 inside the instrument enclosure(temp3)
- Temperature average, sensor 2(temp2)
- Millimeters of precipitation accumulated in the gauge since t he last tare.(total_mm)
- Temperature average, sensor 1(temp1)
- Frequency average, sensor 1(frequency1)
- Frequency average, sensor 2(frequency2)
- Frequency average, sensor 3(frequency3)
- Voltage minimum(volt_min)
- Record with error(error_latch)
- Sensor status(stat_latch)
more
twprainC3.a1: - Millimeters of precipitation accumulated in the gauge since t he last tare.(total_mm)
- Total precipitation over one minute sampling period(precip)
- The latch counter counts number of measurement scans within one minute.(scans_per_min)
- Voltage minimum(volt_min)
- Panel temperature average(ptemp)
- Precipitation intensity(precip_rate)
- Sensor 3 maximum weight(weight3)
- Total maintenance count(maintenance_cnt)
- Sensor status(stat_latch)
- Sensor 2 maximum weight(weight2)
- Temperature average, sensor 2(temp2)
- Temperature average, sensor 1(temp1)
- Sensor 1 maximum weight(weight1)
- Frequency average, sensor 2(frequency2)
- Weight of accumulated precipitation in the gauge since the la st tare(total_weight)
- Frequency average, sensor 1(frequency1)
- Frequency average, sensor 3(frequency3)
- Record with error(error_latch)
- Temperature 3 inside the instrument enclosure(temp3)
more
twprainC3.00: - (Raw data stream - documentation not supported)
more
|