DQRID : D160722.1
Start DateStart TimeEnd DateEnd Time
07/18/2016040007/21/20160500
more
Subject:
AWR/CPC/NEPHELOMETER/PSAP/M1 - Low impactor flow
DataStreams:awraosnephwetM1.a1, awraospsap3wM1.a1, awraosnephdryM1.a1, awraospsaprM1.a0,
awraospsap3wM1.b1, awraospsap3wM1.00, awraosnephdryM1.b1, awraoscpcfM1.b1, awraoscpcfM1.00,
awraoshumidgrM1.00, awraoscpcfM1.a1
Description:
CPC inlet not properly connected to the sample lines. Flow through the impactor below 
nominal. Instruments sampling cabin air at least part of the time.
Suggestions: 
Use data with caution
Measurements:awraoscpcfM1.a1:
  • Condensation temperature(condensation_temp)
  • Flow setpoint(dilution_flow_setpoint)
  • Dilution flow valve position(dilution_valve_position)
  • OPC laser current(laser_current)
  • Liquid fraction available(fraction_full)
  • Aerosol concentration averaged over times to match N_CCN(concentration)
  • Liquid level(liquid_level)
  • Nozzle pressure(nozzle_pressure)
  • Optics temperature(optics_temp)
  • Saturation temperature(saturation_temp)
  • Cabinet temperature(cabinet_temp)
  • Orifice pressure(orifice_pressure)
  • Ambient pressure(ambient_pressure)
  • Flow read(dilution_flow_reading)
more
awraoscpcfM1.00:
  • (Raw data stream - documentation not supported)
more
awraoscpcfM1.b1:
  • Optics temperature(optics_temp)
  • Liquid fraction available(fraction_full)
  • Flow read(dilution_flow_reading)
  • Cabinet temperature(cabinet_temp)
  • Dilution flow valve position(dilution_valve_position)
  • Ambient pressure(ambient_pressure)
  • Saturation temperature(saturation_temp)
  • Aerosol concentration averaged over times to match N_CCN(concentration)
  • Nozzle pressure(nozzle_pressure)
  • OPC laser current(laser_current)
  • Orifice pressure(orifice_pressure)
  • Dilution slope(dilution_slope)
  • Condensation temperature(condensation_temp)
  • Calibrated aerosol flow as supplied by mentor(aerosol_flow_calibrated)
  • Dilution correction factor(dilution_correction_factor)
  • Liquid level(liquid_level)
  • Flow setpoint(dilution_flow_setpoint)
  • Dilution intercept(dilution_intercept)
more
awraosnephdryM1.a1:
  • Sample temperature inside reference nephelometer(T_Neph_Dry)
  • Aerosol back-hemispheric light scattering coefficient, nominal green wavelength
    at dry or reference RH(Bbs_G_Dry_Neph3W)
  • Relative humidity, reference nephelometer(RH_Neph_Dry)
  • Aerosol total light scattering coefficient, nominal green wavelength at dry or
    reference RH(Bs_G_Dry_Neph3W)
  • Temperature, reference nephelometer inlet(T_Neph_Inlet_Dry)
  • Aerosol total light scattering coefficient, nominal red wavelength at dry or
    reference RH(Bs_R_Dry_Neph3W)
  • Aerosol back-hemispheric light scattering coefficient, nominal blue wavelength
    at dry or reference RH(Bbs_B_Dry_Neph3W)
  • Aerosol total light scattering coefficient, nominal blue wavelength at dry or
    reference RH(Bs_B_Dry_Neph3W)
  • Aerosol back-hemispheric light scattering coefficient, nominal red wavelength at
    dry or reference RH(Bbs_R_Dry_Neph3W)
  • Pressure inside reference nephelometer(P_Neph_Dry)
  • Instrument operating mode(mode_flag)
more
awraosnephdryM1.b1:
  • Aerosol back-hemispheric light scattering coefficient, nominal green wavelength
    at dry or reference RH(Bbs_G_Dry_Neph3W)
  • Sample temperature inside reference nephelometer(T_Neph_Dry)
  • Aerosol total light scattering coefficient, nominal red wavelength at dry or
    reference RH(Bs_R_Dry_Neph3W)
  • Impactor state in terms of aerodynamic diameter cut off(impactor_state)
  • Relative humidity, reference nephelometer(RH_Neph_Dry)
  • Aerosol total light scattering coefficient, nominal green wavelength at dry or
    reference RH(Bs_G_Dry_Neph3W)
  • Correction to humidified nephelometer measurements to standard temperature and
    pressure(density_correction_factor)
  • Aerosol back-hemispheric light scattering coefficient, nominal blue wavelength
    at dry or reference RH(Bbs_B_Dry_Neph3W)
  • Aerosol back-hemispheric light scattering coefficient, nominal red wavelength at
    dry or reference RH(Bbs_R_Dry_Neph3W)
  • Pressure inside reference nephelometer(P_Neph_Dry)
  • seconds since last impactor transition(seconds_after_transition)
  • Instrument operating mode(mode_flag)
  • Aerosol total light scattering coefficient, nominal blue wavelength at dry or
    reference RH(Bs_B_Dry_Neph3W)
  • Temperature, reference nephelometer inlet(T_Neph_Inlet_Dry)
more
awraospsaprM1.a0:
  • Red reference sum(red_reference_sum)
  • Dark sample count(dark_sample_count)
  • Green reference sum(green_reference_sum)
  • Blue overflow count(blue_overflow_count)
  • Dark signal sum(dark_signal_sum)
  • Reported flags(flags)
  • Dark overflow count(dark_overflow_count)
  • Red sample count(red_sample_count)
  • Red signal sum(red_signal_sum)
  • Blue signal sum(blue_signal_sum)
  • Mass flow(mass_flow)
  • Dark reference sum(dark_reference_sum)
  • Red overflow count(red_overflow_count)
  • Green signal sum(green_signal_sum)
  • Green sample count(green_sample_count)
  • Blue sample count(blue_sample_count)
  • Mass flow output(mass_flow_output)
  • Green overflow count(green_overflow_count)
  • Blue reference sum(blue_reference_sum)
more
awraoshumidgrM1.00:
  • (Raw data stream - documentation not supported)
more
awraospsap3wM1.a1:
  • Flow setpoint(dilution_flow_setpoint)
  • Mass flow(mass_flow)
  • Aerosol light absorption coefficient, nominal blue wavelength at dry or
    reference RH(Ba_B_PSAP3W)
  • Aerosol light absorption coefficient, nominal red wavelength at dry or reference
    RH(Ba_R_PSAP3W)
  • Dilution flow rate(dilution_flow)
  • AOS Ba_R_CLAP3W transmittance, red channel(transmittance_R)
  • Aerosol light absorption coefficient, nominal green wavelength at dry or
    reference RH(Ba_G_PSAP3W)
  • AOS Ba_B_CLAP3W transmittance, blue channel(transmittance_B)
  • AOS PSAP3W transmittance, green channel(transmittance_G)
  • Diffusion flow valve position(dilution_flow_valve_position)
more
awraosnephwetM1.a1:
  • Temperature, reference nephelometer inlet(T_Neph_Inlet_Wet)
  • Aerosol total light scattering coefficient, nominal green wavelength at ramped
    RH(Bs_G_Wet_Neph3W)
  • Sample temperature inside humidified nephelometer(T_Neph_Wet)
  • Aerosol back-hemispheric light scattering coefficient, nominal red wavelength at
    ramped RH(Bbs_R_Wet_Neph3W)
  • Instrument operating mode(mode_flag)
  • Pressure inside humidified nephelometer(P_Neph_Wet)
  • Aerosol back-hemispheric light scattering coefficient, nominal green wavelength
    at ramped RH(Bbs_G_Wet_Neph3W)
  • Aerosol total light scattering coefficient, nominal red wavelength at ramped RH(Bs_R_Wet_Neph3W)
  • Relative humidity, Humidograph nephelometer(RH_Neph_Wet)
  • Aerosol total light scattering coefficient, nominal blue wavelength at ramped RH(Bs_B_Wet_Neph3W)
more
awraospsap3wM1.00:
  • (Raw data stream - documentation not supported)
more
awraospsap3wM1.b1:
  • Normalization factor for green transmittance, resets with each filter change(transmittance_green_normalization_factor)
  • Instrument flow rate(sample_flow_rate)
  • Filter state(filter_unstable)
  • PSAP3W front panel transmittance relative to new filter, red channel(tr_red)
  • Spot size area(spot_size_area)
  • Transmittance, green channel(transmittance_green)
  • Dilution correction factor(dilution_correction_factor)
  • Normalization factor for blue transmittance, resets with each filter change(transmittance_blue_normalization_factor)
  • Impactor state in terms of aerodynamic diameter cut off(impactor_state)
  • Light absorbance, red channel(absorbance_red)
  • Transmittance, red channel(transmittance_red)
  • Transmittance, blue channel(transmittance_blue)
  • Transmittance, green channel, not normalized(transmittance_green_raw)
  • seconds since last impactor transition(seconds_after_transition)
  • Dilution flow rate(dilution_flow)
  • Transmittance, red channel, not normalized(transmittance_red_raw)
  • Light absorbance, blue channel(absorbance_blue)
  • Diffusion flow valve position(dilution_flow_valve_position)
  • Flow setpoint(dilution_flow_setpoint)
  • Normalization factor for red transmittance, resets with each filter change(transmittance_red_normalization_factor)
  • PSAP3W front panel transmittance relative to new filter, blue channel(tr_blue)
  • Light absorbance, green channel(absorbance_green)
  • Transmittance, blue channel, not normalized(transmittance_blue_raw)
  • PSAP3W front panel transmittance relative to new filter, green channel(tr_green)
more

Close this window