DQRID : D161117.4
Start DateStart TimeEnd DateEnd Time
03/27/2016083403/28/20162000
more
Subject:
SGP/TRACEGAS/S01 - Instrument
DataStreams:sgpaoscoS01.b1, sgpaosso2S01.b1, sgpaosso2S01.00, sgpaoscoS01.a1, sgpaosso2S01.a1,
sgpaoscoS01.00
Description:
REQUIRED
Suggestions: 
Measurements:sgpaoscoS01.b1:  
  • Cell sample pressure(gas_pressure)
  • Quality check results on field: Carbon monoxide (CO) mixing ratio corrected for 
    water vapor concentration and calculated with nominal sensitivity correction(qc_co_dry)
  • Measured water content(h2o)
  • Quality check results on field: Water vapor mixing ratio calculated with nominal 
    sensitivity correction(qc_h2o)
  • Carbon monoxide concentration(co)
  • -180.0 - +180.0(alt)
  • North Latitude(lat)
  • Quality check results on field: Nitrous oxide (N2O) mixing ratio corrected for 
    water vapor concentration and calculated with nominal sensitivity correction(qc_n2o_dry)
  • time_in_seconds_since_volume_start(time)
  • Nitrous oxide (N2O) mixing ratio calculated with nominal sensitivity correction(n2o)
  • Actual mass flow through MFC #2(mass_flow_through_MFC_2)
  • Actual mass flow through mass flow controller 1(mass_flow_through_MFC_1)
  • base time in epoch(base_time)
  • Nitrous oxide (N2O) mixing ratio corrected for water vapor concentration and 
    calculated with nominal sensitivity correction(n2o_dry)
  • Quality check results on field: Nitrous oxide concentration(qc_n2o)
  • lon(lon)
  • Carbon monoxide (CO) mixing ratio corrected for water vapor concentration and 
    calculated with nominal sensitivity correction(co_dry)
  • Cell sample temperature(gas_temperature)
  • Set point for mass flow controller 2(set_point_for_MFC_2)
  • Set point for Mass Flow Controller #1(set_point_for_MFC_1)
  • Valve position for mass flow controller 1(valve_position_MFC_1)
  • Valve position mass flow controller 2(valve_position_MFC_2)
  • Quality check results on field: Carbon monoxide (CO) mixing ratio calculated 
    with nominal sensitivity correction(qc_co)
  • Ambient temperature of instrument(ambient_temperature)
  • Time offset from base_time(time_offset)
  • Seconds after last calibration(seconds_after_calibration)
more

sgpaosso2S01.b1:  
  • Lamp voltage(lamp_volt)
  • -180.0 - +180.0(alt)
  • Averaging time interval(averaging_time)
  • Reaction chamber temperature(reaction_chamber_temp)
  • Main flow rate(flow)
  • Derived pressure(pressure)
  • Quality check results on field: Sulfur dioxide (SO2) mixing ratio calculated 
    with nominal sensitivity correction(qc_so2)
  • SO2 flag string as an integer value(so2_flags)
  • Instrument PMT status(pmt_status)
  • Instrument sample state(gas_mode_state)
  • North Latitude(lat)
  • Distance to the center of the corresponding range bin(range)
  • PMT voltage(pmt_volt)
  • Instrument temperature compensation state(temperature_compensation_state)
  • Instrument flash lamp state(flash_lamp_state)
  • Pressure compensation state(pressure_compensation_state)
  • Instrument purge mode state(purge_mode_state)
  • lon(lon)
  • Instrument SO2 background correction(so2_background_correction)
  • Sulfur dioxide (SO2) mixing ratio calculated with nominal sensitivity correction(so2)
  • base time in epoch(base_time)
  • Set point for mass flow controller 2(set_point_for_MFC_2)
  • Set point for Mass Flow Controller #1(set_point_for_MFC_1)
  • Measure of the current lamp intensity as a percentage of the nominal maximum(lamp_intensity)
  • Actual mass flow through mass flow controller 1(mass_flow_through_MFC_1)
  • Actual mass flow through MFC #2(mass_flow_through_MFC_2)
  • Seconds after last calibration(seconds_after_calibration)
  • Instrument automatic gain control(automatic_gain_control)
  • Instrument lamp setpoint(lamp_setpoint)
  • Valve position mass flow controller 2(valve_position_MFC_2)
  • Valve position for mass flow controller 1(valve_position_MFC_1)
  • Instrument test LED state(test_led)
  • Time offset from base_time(time_offset)
  • Internal instrument temperature(internal_temp)
  • time_in_seconds_since_volume_start(time)
  • Instrument SO2 coefficient(so2_coefficient)
more

sgpaosso2S01.a1:  
  • Diagnostic +15 volts at measurement interface board(diagnostic_voltage_mib_15)
  • North Latitude(lat)
  • Derived pressure(pressure)
  • Instrument PMT status(pmt_status)
  • Actual mass flow through MFC #2(mass_flow_through_MFC_2)
  • Diagnostic -15 volts at measurement interface board(diagnostic_voltage_mib_minus_15)
  • Actual mass flow through mass flow controller 1(mass_flow_through_MFC_1)
  • SO2 flag string as an integer value(so2_flags)
  • Time offset from base_time(time_offset)
  • Instrument SO2 background correction(so2_background_correction)
  • Instrument sample state(gas_mode_state)
  • Pressure compensation state(pressure_compensation_state)
  • Instrument automatic gain control(automatic_gain_control)
  • Diagnostic +5 volts at measurement interface board(diagnostic_voltage_mib_5)
  • Instrument temperature compensation state(temperature_compensation_state)
  • Instrument test LED state(test_led)
  • Lamp voltage(lamp_volt)
  • Internal instrument temperature(internal_temp)
  • -180.0 - +180.0(alt)
  • Diagnostic +24 volts at measurement interface board(diagnostic_voltage_mib_24)
  • Instrument purge mode state(purge_mode_state)
  • Instrument SO2 coefficient(so2_coefficient)
  • Set point for mass flow controller 2(set_point_for_MFC_2)
  • Set point for Mass Flow Controller #1(set_point_for_MFC_1)
  • Valve position mass flow controller 2(valve_position_MFC_2)
  • Valve position for mass flow controller 1(valve_position_MFC_1)
  • Diagnostic +5 volts at motherboard(diagnostic_voltage_mb_5)
  • Diagnostic +3.3 volts at measurement interface board(diagnostic_voltage_mib_3p3)
  • Instrument lamp setpoint(lamp_setpoint)
  • Sulfur dioxide (SO2) mixing ratio calculated with nominal sensitivity correction(so2)
  • Main flow rate(flow)
  • time_in_seconds_since_volume_start(time)
  • Diagnostic +3.3 volt at motherboard(diagnostic_voltage_mb_3p3)
  • lon(lon)
  • base time in epoch(base_time)
  • Diagnostic voltage +24 volts at motherboard(diagnostic_voltage_mb_24)
  • Diagnostic -3.3 volts at motherboard(diagnostic_voltage_mb_minus_3p3)
  • Reaction chamber temperature(reaction_chamber_temp)
  • PMT voltage(pmt_volt)
  • Measure of the current lamp intensity as a percentage of the nominal maximum(lamp_intensity)
  • Distance to the center of the corresponding range bin(range)
  • Averaging time interval(averaging_time)
  • Instrument flash lamp state(flash_lamp_state)
  • Diagnostic +15 volts at motherboard(diagnostic_voltage_mb_15)
more

sgpaoscoS01.a1:  
  • Measured water content(h2o)
  • Time offset from base_time(time_offset)
  • base time in epoch(base_time)
  • North Latitude(lat)
  • Carbon monoxide (CO) mixing ratio corrected for water vapor concentration and 
    calculated with nominal sensitivity correction(co_dry)
  • -180.0 - +180.0(alt)
  • Valve position mass flow controller 2(valve_position_MFC_2)
  • Valve position for mass flow controller 1(valve_position_MFC_1)
  • time_in_seconds_since_volume_start(time)
  • Nitrous oxide (N2O) mixing ratio calculated with nominal sensitivity correction(n2o)
  • Nitrous oxide (N2O) mixing ratio corrected for water vapor concentration and 
    calculated with nominal sensitivity correction(n2o_dry)
  • Cell sample pressure(gas_pressure)
  • Cell sample temperature(gas_temperature)
  • Actual mass flow through MFC #2(mass_flow_through_MFC_2)
  • Ambient temperature of instrument(ambient_temperature)
  • Actual mass flow through mass flow controller 1(mass_flow_through_MFC_1)
  • lon(lon)
  • Set point for mass flow controller 2(set_point_for_MFC_2)
  • Set point for Mass Flow Controller #1(set_point_for_MFC_1)
  • Carbon monoxide concentration(co)
more

sgpaosso2S01.00:  
  • (Raw data stream - documentation not supported)
more

sgpaoscoS01.00:  
  • (Raw data stream - documentation not supported)
more


Close this window