SGP/SONDE/C1 - Surface pressure incorrect

I think the operator inadvdertently entered an incorrect surface pressure value.  The 
value entered is 988.8 hPa but the value shown in the raw data file at launch is 968.8.  As a 
result, the absolute altitudes in this sounding will be slightly incorrect as will be 
the ascent rate during the first 30 seconds of flight.

• Ascent Rate(asc)
• altitude above sea levelaltunits(alt)

SGP/SONDE/C1 - Surface pressure bad and other data noisy

I was checking this sounding because the surface pressure entered by the operator was 
considerably higher than that recorded by the TWHAPS and SMOS.  I'm not sure why, but the 
pressure data are very noisy while the sonde is on the ground (which accounts for the 
incorrect surface pressure) and the RH data aloft do not look terrible but do not look great 
either.

• Surface dew point temperature(dp)
• Time offset from base_time(base_time)
• surface wind speed(wspd)
• model zonal wind velocity(u_wind)
• Relative humidity scaled, by total column amount from MWR(rh)
• north latitude for all the input platforms.(lat)
• Ascent Rate(asc)
• pressure at constant pressure surface(pres)
• Wind Direction(deg)
• Wind Status(wstat)
• east longitude for all the input platforms.(lon)
• Dry-Bulb Temperature(tdry)
• Time offset of tweaks from base_time(time_offset)
• model meridional wind velocity(v_wind)
• altitude above sea levelaltunits(alt)

SGP/SONDE/C1 - Surface pressure incorrect

I think the operator inadvdertently typed an 89 instead of a 78 when entering the surface 
pressure value.  The value entered is 989.9 hPa but the value shown in the raw data file 
at launch is 978.9.  As a result, the absolute altitudes in this sounding will be 
slightly incorrect as will be the ascent rate during the first 30 seconds of flight.

• Ascent Rate(asc)
• altitude above sea levelaltunits(alt)

SGP/SONDE/C1 - Surface pressure incorrect

I think the operator inadvdertently mistyped a digit when entering the surface pressure 
value.  The value entered is 975.6 hPa but the value shown in the raw data file at launch 
is 972.6.  As a result, the absolute altitudes in this sounding will be slightly incorrect 
as will be the ascent rate during the first 30 seconds of flight.

• Ascent Rate(asc)
• altitude above sea levelaltunits(alt)

SGP/SONDE/C1 - Sonde RH values incorrect

RH values for all sondes launched during this time were incorrect due to a faulty Ground 
Check set which damaged or conditioned the RH sensor improperly.

• Surface dew point temperature(dp)
• Relative humidity scaled, by total column amount from MWR(rh)