DQR ID | Subject | Data Streams Affected |
---|---|---|
D050624.5 | PYE/SONDE/M1 - Reprocess: Incorrect surface temperature and RH | pyelssondeM1.c1, pyesondewnpnM1.b1 |
D050811.6 | PYE/SONDE/M1 - Broken RH sensor | pyesondewnpnM1.b1 |
D050823.1 | PYE/SONDE/M1 - Bad temperature and RH | pyesondewnpnM1.b1 |
D050912.3 | PYE/SONDE/M1 - Bad RH sensor | pyesondewnpnM1.b1 |
D050912.4 | PYE/SONDE/M1 - Bad RH sensor | pyesondewnpnM1.b1 |
Start Date | Start Time | End Date | End Time |
---|---|---|---|
05/02/2005 | 1126 | 05/02/2005 | 1127 |
06/04/2005 | 1729 | 06/04/2005 | 1903 |
06/05/2005 | 1128 | 06/06/2005 | 1254 |
06/11/2005 | 1728 | 06/12/2005 | 0143 |
06/13/2005 | 1127 | 06/13/2005 | 1136 |
Subject: | PYE/SONDE/M1 - Reprocess: Incorrect surface temperature and RH |
DataStreams: | pyelssondeM1.c1, pyesondewnpnM1.b1 |
Description: | This DQR applies to ten soundings done during the indicated time periods. In all cases, the operators entered the indoor temperature rather than the outdoor temperature and RH as the first point in the sounding. This distorts the temperature and RH measurements in the lowest part of the profile. |
Measurements: | pyesondewnpnM1.b1:
pyelssondeM1.c1:
|
Start Date | Start Time | End Date | End Time |
---|---|---|---|
08/02/2005 | 1129 | 08/02/2005 | 1225 |
Subject: | PYE/SONDE/M1 - Broken RH sensor |
DataStreams: | pyesondewnpnM1.b1 |
Description: | One of the RH sensors on this radiosonde was bad. The RH oscillates rapidly between near 0 and ambient up to approximately 11 km. The near-zero values are incorrect. |
Measurements: | pyesondewnpnM1.b1:
|
Start Date | Start Time | End Date | End Time |
---|---|---|---|
06/30/2005 | 0528 | 06/30/2005 | 0711 |
Subject: | PYE/SONDE/M1 - Bad temperature and RH |
DataStreams: | pyesondewnpnM1.b1 |
Description: | The temperature appears to be approximately 10 degC too high during the entire sounding. This also causes the RH to be too low. Most likely the problem was a bad temperature sensor. |
Measurements: | pyesondewnpnM1.b1:
|
Start Date | Start Time | End Date | End Time |
---|---|---|---|
08/31/2005 | 1130 | 08/31/2005 | 1140 |
Subject: | PYE/SONDE/M1 - Bad RH sensor |
DataStreams: | pyesondewnpnM1.b1 |
Description: | The RH sensor heating circuit failed on this sounding. RH values during the first part of the sounding oscillate between a reasonable value and a very low value. It appears that (a) the heating was out of phase, and (b) incorrect values were being reported during the first 10 minutes or so of flight. |
Measurements: | pyesondewnpnM1.b1:
|
Start Date | Start Time | End Date | End Time |
---|---|---|---|
08/29/2005 | 1128 | 08/29/2005 | 1340 |
Subject: | PYE/SONDE/M1 - Bad RH sensor |
DataStreams: | pyesondewnpnM1.b1 |
Description: | Two problems here - failure of the RH sensor heating circuit and a bad RH sensor. |
Measurements: | pyesondewnpnM1.b1:
|