Data Quality Reports for Session: 104028 User: milo Completed: 02/01/2007


TABLE OF CONTENTS

DQR IDSubjectData Streams Affected
D060208.2SGP/SONDE/C1 - Mixed use of RS92-SGP and RS92-KL radiosondessgpsondewnpnC1.b1
D060717.2SGP/MWR/C1 - Spikes in ambient temperature readingssgpmwrlosC1.b1, sgpmwrtipC1.a1
D060821.3SGP/MWR/C1 - Missing datasgpmwrlosC1.b1, sgpmwrtipC1.a1
D060928.2SGP/SONDE/C1 - RH values offset due to error in ground checksgpsondewnpnC1.b1
D060928.3SGP/SONDE/C1 - Increased precision for alt, dp, pres, rh, tdrysgpsondewnpnC1.b1


DQRID : D060208.2
Start DateStart TimeEnd DateEnd Time
02/10/2006000012/31/20062359
Subject:
SGP/SONDE/C1 - Mixed use of RS92-SGP and RS92-KL radiosondes
DataStreams:sgpsondewnpnC1.b1
Description:
Because of a manufacturer's production problem, we will be using both RS92-SGP (GPS 
windfinding and RS92-KL (Loran windfinding) radiosondes at the SGP/CF starting February 10, 
2006.  The radiosonde type used for the each sounding may be determined by looking the 
metadata variable "launch_status" in the netCDF data files.
Measurements:sgpsondewnpnC1.b1:
  • east longitude for all the input platforms.(lon)
  • model zonal wind velocity(u_wind)
  • surface wind speed(wspd)
  • model meridional wind velocity(v_wind)
  • north latitude for all the input platforms.(lat)
  • Wind Direction(deg)
  • Wind Status(wstat)


Back To Table of Contents

DQRID : D060717.2
Start DateStart TimeEnd DateEnd Time
07/13/2006120007/28/20061600
Subject:
SGP/MWR/C1 - Spikes in ambient temperature readings
DataStreams:sgpmwrlosC1.b1, sgpmwrtipC1.a1
Description:
There are intermittent spikes in the Tkair temperature (T ~ 400 K). On 7/28 the sensor 
was cleaned and the instrument power cycled following a power outage. Readings came back to 
normal.
Measurements:sgpmwrtipC1.a1:
  • Ambient temperature(tkair)

sgpmwrlosC1.b1:
  • Ambient temperature(tkair)


Back To Table of Contents

DQRID : D060821.3
Start DateStart TimeEnd DateEnd Time
07/01/2006230007/03/20061400
Subject:
SGP/MWR/C1 - Missing data
DataStreams:sgpmwrlosC1.b1, sgpmwrtipC1.a1
Description:
Data are missing because of a SW problem
Measurements:sgpmwrtipC1.a1:
  • 31.4 GHz blackbody+noise injection signal(bbn31)
  • 31.4 GHz Blackbody signal(bb31)
  • Noise injection temp at 23.8 GHz adjusted to tkbb(tnd23)
  • Noise diode mount temperature(tknd)
  • Water on Teflon window (1=WET, 0=DRY)(wet_window)
  • Total liquid water along zenith path using tip-derived brightness temperatures(liqtip)
  • Noise injection temp at 31.4 GHz adjusted to tkbb(tnd31)
  • Actual elevation angle(actel)
  • Blackbody kinetic temperature(tkbb)
  • 23.8 GHz Blackbody signal(bb23)
  • Temperature correction coefficient at 23.8 GHz(tc23)
  • north latitude for all the input platforms.(lat)
  • Ambient temperature(tkair)
  • Mixer kinetic (physical) temperature(tkxc)
  • 23.8 GHz blackbody+noise injection signal(bbn23)
  • altitude above sea levelaltunits(alt)
  • Noise injection temp at 23.8 GHz derived from this tip(tnd23I)
  • 31.4 GHz sky signal(tipsky31)
  • Noise injection temp at 31.4 GHz derived from this tip(tnd31I)
  • Temperature correction coefficient at 31.4 GHz(tc31)
  • Actual Azimuth(actaz)
  • Time offset from base_time(base_time)
  • Noise injection temp at nominal temperature at 31.4 GHz(tnd_nom31)
  • east longitude for all the input platforms.(lon)
  • 23.8 GHz sky signal(tipsky23)
  • Time offset of tweaks from base_time(time_offset)
  • Total water vapor along zenith path using tip-derived brightness temperatures(vaptip)
  • Noise injection temp at nominal temperature at 23.8 GHz(tnd_nom23)
  • 31.4 GHz sky brightness temperature derived from tip curve(tbsky31tip)
  • 31.4 GHz goodness-of-fit coefficient(r31)
  • 23.8 GHz sky brightness temperature derived from tip curve(tbsky23tip)
  • 23.8 GHz goodness-of-fit coefficient(r23)

sgpmwrlosC1.b1:
  • 31.4 GHz sky signal(sky31)
  • Water on Teflon window (1=WET, 0=DRY)(wet_window)
  • altitude above sea levelaltunits(alt)
  • 31.4 GHz blackbody+noise injection signal(bbn31)
  • Noise injection temp at nominal temperature at 31.4 GHz(tnd_nom31)
  • 23.8 GHz sky signal(sky23)
  • Mean 31.4 GHz sky brightness temperature(tbsky31)
  • east longitude for all the input platforms.(lon)
  • Noise injection temp at 31.4 GHz adjusted to tkbb(tnd31)
  • Mean total liquid water amount along LOS path(liq)
  • 31.4 GHz Blackbody signal(bb31)
  • Noise injection temp at nominal temperature at 23.8 GHz(tnd_nom23)
  • Temperature correction coefficient at 31.4 GHz(tc31)
  • Blackbody kinetic temperature(tkbb)
  • Sky/Cloud Infra-Red Temperature(sky_ir_temp)
  • Mean total water vapor amount along LOS path(vap)
  • Ambient temperature(tkair)
  • 23.8 GHz Blackbody signal(bb23)
  • Mean 23.8 GHz sky brightness temperature(tbsky23)
  • Mixer kinetic (physical) temperature(tkxc)
  • Time offset of tweaks from base_time(time_offset)
  • Time offset from base_time(base_time)
  • Noise diode mount temperature(tknd)
  • Noise injection temp at 23.8 GHz adjusted to tkbb(tnd23)
  • 23.8 GHz blackbody+noise injection signal(bbn23)
  • Temperature correction coefficient at 23.8 GHz(tc23)
  • north latitude for all the input platforms.(lat)


Back To Table of Contents

DQRID : D060928.2
Start DateStart TimeEnd DateEnd Time
08/27/2006233209/25/20061600
Subject:
SGP/SONDE/C1 - RH values offset due to error in ground check
DataStreams:sgpsondewnpnC1.b1
Description:
Background: After installation of the latest software update , we began performing formal 
ground checks on RS92 radiosondes.  By comparing the
radiosonde readings with reference values in a controlled environment, the
ground check is intended to ensure that the radiosonde sensors are in
calibration before launch.  The radisonde values during the ground check
process are recorded automatically; the reference values are entered by the
operator.  If the radiosonde readings vary from the reference values, the
system 'corrects' the radiosonde values.  In the case of RH, the correction
is applied as an offset (true RH = indicated RH + correction).

Problem: Some operators misunderstood the ground-check procedure and entered the 
radiosonde values of RH rather than the reference value (assumed 0%RH), thus, some soundings done 
during this period have RH values that are different from what they would be if the 
ground check procedure had been done correctly.

Consequence:  Because the RH corrections generally are small (averaging
about 0.5% RH) and the precision of the reported RH data during this time
period is 1% RH, some values will not be affected at all; others will be off by about 1% 
RH (still within the stated accuracy of the sensor). 
Furthermore, because entering the radiosonde value as the reference value
results in a near zero 'correction,' one may view these soundings as being
done without the ground check correction.  Also note that the dew point
value will be suspect as well.

I am attaching below a listing of the soundings that were affected during the indicated 
time period.  Users can see the magnitude of the problem and choose whether or not to apply 
an offset in RH.  Note that application of the offset to the processed RH data (in the 
netCDF file) will not have the same effect of applying the correction to the absolutely 
raw data (before processing), but the differences should be insignificant.  Also note that 
the corrections for each sounding are included in the netCDF header information.  These 
attributes are named 'humidity_correction' and 'humidity_correction_2'.  The values of RH 
indicated by the radiosonde while it is in the ground check set are in attributes 
'humidity_gc_sonde' and 'humidity_gc_sonde_2.'  There is an RH reading for each of the two RH 
sensors used in the RS92 radiosonde.

Here is the list - RH1 and RH2 are the radiosonde readings in the ground
check set.  Ref is the reference value entered by the operator.  The
correcte reference value should be 0%.  To obtain an approximation to the RH value that 
would have been recorded if the ground check had been done
properly, subtract the Ref value from the indicated RH.

 YYYYMMDD  HHMM  SerialN      RH1     RH2     Ref
 20060827  2332  B2624322    1.00    1.00    1.00
 20060828  1731  B2634078    1.00    1.00    1.00
 20060828  2332  B2624380    3.00    3.00    2.00
 20060909  2331  B2615266    1.00    1.00    1.00
 20060915  1759  B2914012    1.00    1.00    1.00
 20060919  2350  B2825128    1.00    1.00    1.00
 20060920  1800  B2825088    1.00    1.00    1.00
 20060920  2346  B2815633    1.00    1.00    1.00
 20060921  1728  B2834732    1.30    1.30    1.30
 20060921  2330  B2825042    1.50    1.50    1.50
 20060922  0527  B2825043    1.70    1.80    1.70
 20060922  1128  B2825031    1.60    1.50    1.60
 20060922  1729  B2834437    1.50    1.50    1.50
 20060922  2330  B2825040    0.40    0.50    0.50
 20060923  0529  B2834733    0.30    0.30    0.30
 20060923  1128  B2825026    0.40    0.40    0.40
 20060923  1729  B2825064    0.60    0.70    0.60
 20060923  2330  B2825041    0.40    0.50    0.50
 20060924  0529  B2825039    0.30    0.30    0.30
 20060924  1729  B2825025    0.20    0.30    0.20
 20060924  2329  B2825032    0.30    0.40    0.40
 20060925  0529  B2824234    0.20    0.30    0.20
Measurements:sgpsondewnpnC1.b1:
  • Surface dew point temperature(dp)
  • Relative humidity scaled, by total column amount from MWR(rh)


Back To Table of Contents

DQRID : D060928.3
Start DateStart TimeEnd DateEnd Time
09/28/2006172812/31/99992359
Subject:
SGP/SONDE/C1 - Increased precision for alt, dp, pres, rh, tdry
DataStreams:sgpsondewnpnC1.b1
Description:
The output precision of the following variables was increased 20060928

alt  changed from 1m to 0.1m
dp   changed from 0.1degC to 0.01degC
pres changed from 0.1 hPa to 0.01 hPa
RH   changed from 1%RH to 0.01%RH
tdry changed from .1degC to 0.01degC

Note that the increase in precision does not necessarily imply an increase in accuracy.  
Users are cautioned to continue to use their best scientific judgement when using these or 
any other data.
Measurements:sgpsondewnpnC1.b1:
  • Surface dew point temperature(dp)
  • Dry-Bulb Temperature(tdry)
  • Relative humidity scaled, by total column amount from MWR(rh)
  • pressure at constant pressure surface(pres)
  • altitude above sea levelaltunits(alt)


Back To Table of Contents



END OF DATA