TWP/SMET/C3 - ORG data noisy due to degraded ground

SMET Rain Data began to be noisy during December 2005 and the problem slowly became worse 
over time so that in February 2006 the ORG was reporting with a constant background value 
of around 0.10 mm/hr rain rate.  ORG voltage showed a near constant value above the 85mV 
threshold.  The ground for the ORG had become degraded and was lost due to corrosion.

• Precipitation mean(precip_mean)
• Precipitation maximum(precip_max)
• Precipitation standard deviation(precip_sd)
• precipitation minimum(precip_min)

TWP/SMET/C3 - Anemometer Readings Incorrect

The Anemometer readings were incorrect due to the tower being lowered for maintenance.

• Wind #2 speed arithmetic average(wind2_spd_arith_avg)
• Wind #1 speed minimum(wind1_spd_min)
• Wind #1 direction vector average(wind1_dir_vec_avg)
• Wind #1 speed standard deviation(wind1_spd_sd)
• Wind #2 speed maximum(wind2_spd_max)
• Wind #1 speed vector average(wind1_spd_vec_avg)
• Wind #2 direction vector average(wind2_dir_vec_avg)
• Wind #1 direction standard deviation(wind1_dir_sd)
• Wind #2 speed vector average(wind2_spd_vec_avg)
• Wind #2 speed maximum gust(wind2_spd_max_gust)
• Wind #1 speed maximum(wind1_spd_max)
• Wind #2 speed minimum(wind2_spd_min)
• Wind #1 speed maximum gust(wind1_spd_max_gust)
• Wind #1 speed arithmetic average(wind1_spd_arith_avg)
• Wind #2 direction standard deviation(wind2_dir_sd)
• Wind #2 speed standard deviation(wind2_spd_sd)

TWP/SMET/C3 - Reprocess: Barometric Data Changed from hPa to kPa

Barometric pressure data was converted from hPa to kPa in order to standardize the 
measurement units among ARM sites and to conform to accepted standard units determined by the 
scientific community.

• Atmospheric pressure(atmos_pressure)

TWP/SMET/C3 - Reprocess: Tipping bucket rain gauge added

A tipping bucket rain gauge was added to the SMET suite of instruments effective 20060926. 
 Two new variables (count and rain amount) were added at the end of the twpsmet60sC1.b1 
datastream.  When reprocessing of this datastream occurs these variables will be added 
with -9999 (missing) as the value for dates prior to gauge installation.

• Time offset from base_time(base_time)

TWP/SMET/C3 - Barometer Data Incorrect

The barometer data was incorrect or missing due to water intrusion.

• Atmospheric pressure(atmos_pressure)

TWP/SMET/C3 - Data Incorrect Due to Water Intrusion

Data became erratic and unreasonable after water intrusion into the enclosure.

• Vapor pressure standard deviation(vappress_sd)
• Precipitation maximum(precip_max)
• Relative humidity maximum(relh_max)
• Relative humidity mean(relh_mean)
• Std Dev of Relative Humidity or Hardware Error Code(relh_sd)
• Relative humidity minimum(relh_min)
• precipitation minimum(precip_min)
• Precipitation mean(precip_mean)
• Min Temperature at lowest Model Level- 1 hr(temp_min)
• Mean Air Temperature or Hardware Error(temp_mean)
• Max Temperature at lowest Model Level- 1 hr(temp_max)
• Precipitation standard deviation(precip_sd)
• Vapor pressure mean(vappress_mean)
• Temperature standard deviation(temp_sd)