Data Quality Reports for Session: 105574 User: turner Completed: 05/10/2007


TABLE OF CONTENTS

DQR IDSubjectData Streams Affected
D070411.3SGP/RWP/C1 - no moments data are availablesgp915rwptempmomC1.a0, sgp915rwpwindmomC1.a0
D070411.4SGP/RWP/I3 - no usable moments data availablesgp915rwptempmomI3.a0, sgp915rwpwindmomI3.a0


DQRID : D070411.3
Start DateStart TimeEnd DateEnd Time
09/26/2006000004/05/20071659
Subject:
SGP/RWP/C1 - no moments data are available
DataStreams:sgp915rwptempmomC1.a0, sgp915rwpwindmomC1.a0
Description:
When the upgrade to the Central Facility rwp was installed, the interpretation of the 
configuration file changed  such that it became necessary to explicitly require that moments 
data be saved within the raw spectral data file.  Previously this was not true.   The 
ingest operates in such a way that it just goes a certain number of bytes into the spectral 
data and takes the following section.  Thus bogus moments data files were bing ingested 
that had essentially no usable information insofar as moments data are concerned.  Thus 
there are no usable moments data files from this time period.  At this time I have not been 
able to determine a method to recreate the raw moments files from the spectral data in 
any straightforward manner that would result in files with the precise format as presently used.
Measurements:sgp915rwptempmomC1.a0:
  • Mean atmospheric vertical velocity(mdf)
  • RASS virtual temperature (1st moment)(virtual_temp)
  • Sample Rate(sampr)
  • Acoustic Spectral Width(sspecw)
  • Mean acoustic speed(smdf)
  • Spectral Width: vert velocity(specw)
  • east longitude for all the input platforms.(lon)
  • Height of bins above ground level for the temperature, retrieved water vapor,
    and pressure profile(height)
  • Time offset from base_time(base_time)
  • altitude above sea levelaltunits(alt)
  • Signal to Noise Ratio of the RASS Signal(snr)
  • Time offset of tweaks from base_time(time_offset)
  • 1000 * log10(noise signal level: vert vel)(noise)
  • Signal to Noise Ratio: acoustic(ssnr)
  • north latitude for all the input platforms.(lat)
  • Range Gate Spacing(rgs)

sgp915rwpwindmomC1.a0:
  • Interpulse Period(ipp)
  • Oblique FFT Bandwidth(oband)
  • Beam Number(beam)
  • Delay Time to 1st Gate(dly)
  • Pulse Length(plen)
  • Signal to Noise Ratio of the RASS Signal(snr)
  • Elevation angle of Beam 0(elevation)
  • Number of Coherent Samples/spectral point(ncoh)
  • Time Domain Integration Time(tditime)
  • Pulse Repetition Frequency(prf)
  • Height Index(range_gate)
  • Height of Center of First Range Gate(rgf)
  • north latitude for all the input platforms.(lat)
  • Time offset of tweaks from base_time(time_offset)
  • Range Gate Spacing(rgs)
  • 1000 * log10(noise signal level: vert vel)(noise)
  • Sample Rate(sampr)
  • Number of valid heights for each power(nheight)
  • Vertical FFT Bandwidth(vband)
  • Individual Spectrum Integration Time(sitime)
  • altitude above sea levelaltunits(alt)
  • Spectral Width: vert velocity(specw)
  • Height of Center of Last Range Gate(rgl)
  • Ave Time per Average Spectra. Also known as dwell.(spcavetime)
  • Array of heights for each sample time(height_t)
  • Number of Individual Spectra/Average Spectrum(nspc)
  • east longitude for all the input platforms.(lon)
  • Mean atmospheric vertical velocity(mdf)
  • Rx bandwidth switch code(bswitch)
  • Time offset from base_time(base_time)
  • Number of Pulse Code Bits(pcbits)
  • Radial Velocity Spectral Resolution(vsr)


Back To Table of Contents

DQRID : D070411.4
Start DateStart TimeEnd DateEnd Time
09/27/2006000004/11/20072300
Subject:
SGP/RWP/I3 - no usable moments data available
DataStreams:sgp915rwptempmomI3.a0, sgp915rwpwindmomI3.a0
Description:
When the upgrade to the Central Facility rwp was installed, the interpretation of the 
configuration file changed  such that it became necessary to explicitly require that moments 
data be saved within the raw spectral data file.  Previously this was not true.   The 
ingest operates in such a way that it just goes a certain number of bytes into the spectral 
data and takes the following section.  Thus bogus moments data files were bing ingested 
that had essentially no usable information insofar as moments data are concerned.  Thus 
there are no usable moments data files from this time period.  At this time I have not been 
able to determine a method to recreate the raw moments files from the spectral data in 
any straightforward manner that would result in files with the precise format as presently used.
Measurements:sgp915rwpwindmomI3.a0:
  • Time Domain Integration Time(tditime)
  • north latitude for all the input platforms.(lat)
  • Time offset from base_time(base_time)
  • Individual Spectrum Integration Time(sitime)
  • Array of heights for each sample time(height_t)
  • Pulse Repetition Frequency(prf)
  • Rx bandwidth switch code(bswitch)
  • Interpulse Period(ipp)
  • Vertical FFT Bandwidth(vband)
  • Number of Individual Spectra/Average Spectrum(nspc)
  • east longitude for all the input platforms.(lon)
  • Time offset of tweaks from base_time(time_offset)
  • Oblique FFT Bandwidth(oband)
  • Signal to Noise Ratio of the RASS Signal(snr)
  • Delay Time to 1st Gate(dly)
  • Elevation angle of Beam 0(elevation)
  • Number of Pulse Code Bits(pcbits)
  • Number of valid heights for each power(nheight)
  • Sample Rate(sampr)
  • Height Index(range_gate)
  • Beam Number(beam)
  • Number of Coherent Samples/spectral point(ncoh)
  • Spectral Width: vert velocity(specw)
  • altitude above sea levelaltunits(alt)
  • 1000 * log10(noise signal level: vert vel)(noise)
  • Radial Velocity Spectral Resolution(vsr)
  • Pulse Length(plen)
  • Ave Time per Average Spectra. Also known as dwell.(spcavetime)
  • Height of Center of First Range Gate(rgf)
  • Mean atmospheric vertical velocity(mdf)
  • Height of Center of Last Range Gate(rgl)
  • Range Gate Spacing(rgs)

sgp915rwptempmomI3.a0:
  • RASS virtual temperature (1st moment)(virtual_temp)
  • Height of bins above ground level for the temperature, retrieved water vapor,
    and pressure profile(height)
  • Sample Rate(sampr)
  • Signal to Noise Ratio of the RASS Signal(snr)
  • 1000 * log10(noise signal level: vert vel)(noise)
  • Time offset of tweaks from base_time(time_offset)
  • Signal to Noise Ratio: acoustic(ssnr)
  • north latitude for all the input platforms.(lat)
  • east longitude for all the input platforms.(lon)
  • Range Gate Spacing(rgs)
  • Acoustic Spectral Width(sspecw)
  • Mean atmospheric vertical velocity(mdf)
  • Mean acoustic speed(smdf)
  • altitude above sea levelaltunits(alt)
  • Spectral Width: vert velocity(specw)
  • Time offset from base_time(base_time)


Back To Table of Contents



END OF DATA