Description: | The KAZR continues to undergo evaluation by the radar instrument mentors, ProSensing, VAP
developers, DQ Office, site scientists, users, etc. As more in-depth analysis and
calibration studies take place, we anticipate that new insights will be gained to increase the
quality of the data and decrease the uncertainty of the measurements. This is a
continuous improvement process and issues will be addressed as they are discovered.
Calibration is very important. With the addition of Ka-SACRs adjacent to the KAZRs, this
will give us an unprecedented method of doing calibration comparisons. The Ka-SACR will
be able to use an external calibration target to include those components that are not
calibrated by internal circuits. We will not be able to point the KAZR at a calibration
target but by comparing radar returns to the Ka-SACR, we will be able to achieve a higher
degree of calibration than we ever could with the KAZR operating standalone as its
predecessor, the MMCR, did.
As issues are discovered, attempts will be made to correct data that is currently in the
Archive. However, retrospective correction of errors due calibration, signal processing,
component degradation and software bugs may not be possible for many of the data files.
This open-ended DQR is an advisory that some aspects of the data quality are not yet
known. It is also a request for users that find issues or questions with the data to contact
the ARM Radar Engineering & Operations Group Manager, Kevin Widener, at
kevin.widener@pnnl.gov as these issues occur so that they can be investigated and corrected if necessary. |
Measurements: | gankazrgeM1.b1: - qc_time
- Spectral width, cross-polar(spectral_width_xpol)
- Spectral width, copolar(spectral_width_copol)
- Reflectivity, copolar(reflectivity_copol)
- time
- cal_constant_copol
- Reflectivity, cross-polar(reflectivity_xpol)
- Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
- base_time
- signal_to_noise_ratio_copol
- time_offset
- range
- signal_to_noise_ratio_xpol
- Mean doppler velocity, copolar(mean_doppler_velocity_copol)
- cal_constant_xpol
- rx_noise
gankazrciM1.b1: - cal_constant_xpol
- cal_constant_copol
- signal_to_noise_ratio_xpol
- Reflectivity, copolar(reflectivity_copol)
- Spectral width, copolar(spectral_width_copol)
- range
- Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
- Reflectivity, cross-polar(reflectivity_xpol)
- Spectral width, cross-polar(spectral_width_xpol)
- Mean doppler velocity, copolar(mean_doppler_velocity_copol)
- signal_to_noise_ratio_copol
- time_offset
- time
- qc_time
- base_time
- rx_noise
gankazrspeccmaskblcopolM1.a0: - velocity_bins
- time_offset
- base_time
- range
- Spectrum of raw counts from spectrometer(spectra)
- signal_to_noise_ratio
- Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
- locator_mask
- time
- Daily values of reflectivity on each grid cell(reflectivity)
- Spectral Width(spectral_width)
gankazrspeccmaskgecopolM1.a0: - time_offset
- locator_mask
- time
- base_time
- Daily values of reflectivity on each grid cell(reflectivity)
- range
- Spectral Width(spectral_width)
- Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
- signal_to_noise_ratio
- Spectrum of raw counts from spectrometer(spectra)
- velocity_bins
gankazrblM1.b1: - time_offset
- base_time
- Mean doppler velocity, cross-polar(mean_doppler_velocity_xpol)
- cal_constant_xpol
- signal_to_noise_ratio_xpol
- Spectral width, copolar(spectral_width_copol)
- time
- Pitch angle reported by tilt table(pitch)
- Spectral width, cross-polar(spectral_width_xpol)
- Reflectivity, copolar(reflectivity_copol)
- Mean doppler velocity, copolar(mean_doppler_velocity_copol)
- signal_to_noise_ratio_copol
- range
- rx_noise
- Reflectivity, cross-polar(reflectivity_xpol)
- Roll angle reported by tilt table(roll)
- cal_constant_copol
gankazrspeccmaskcicopolM1.a0: - base_time
- Spectral Width(spectral_width)
- Mean Doppler velocity, clutter filtered(mean_doppler_velocity)
- Spectrum of raw counts from spectrometer(spectra)
- locator_mask
- time_offset
- velocity_bins
- signal_to_noise_ratio
- time
- range
- Daily values of reflectivity on each grid cell(reflectivity)
gankazrauxM1.a1: - input_5V
- temp_circulator
- power_supply_28V
- temp_outside_air
- pdu_status_j1_logic
- input_minus5V
- rh_antenna
- rx_gain_ch1
- rx_gain_ch2
- time
- spare_analog_j12_1
- temp_noise_diode
- rx_noise_ch2
- rx_noise_ch1
- temp_antenna_feedhorn
- j2_logic
- cal_constant_ch2_xpol
- temp_power_supply
- rh_local
- is_powered_on
- lock_alarm_360
- input_8V
- noise_source_ch2
- noise_source_ch1
- temp_reverse_power
- lock_alarm_1620
- timing_mode
- cal_constant_ch1_xpol
- time_offset
- input_12V
- fault_flags
- cal_constant_ch1_copol
- fft_taper_type
- remote_control_enabled
- cal_constant_ch2_copol
- power_supply_5p2V
- processing_mode
- temp_local
- temp_lna
- input_15V
- temp_component_plate
- twta_status_state
- lock_alarm_120
- tx_power
- base_time
- temp_rf_detector
- temp_antenna
- lock_alarm_16560
- power_supply_5V
|