| Measurements |
- overlap_correction_heights (Heights for overlap correction)
- background_signal_std_cross_pol (Background signal standard deviation, cross pol data)
- background_signal_co_pol (Background signal, copol data)
- num_bins (Number of bins stored in data block)
- height (Height above ground of the center of corresponding range_bin)
- range (Distance from transceiver to center of corresponding range_bin)
- shots_per_avg (Number of laser pulses summed during averaging interval)
- polarization_control (Polarization control enabled flag)
- range_bins (Distance from leading edge of first range bin to the center of each bin.)
- mcs_mode (MCS mode register.)
- range_bin_width (Width of range-bins calculated from range_bin_time)
- dead_time_corrected (Dead time correction flag)
- num_channels (Number of detector channels)
- deadtime_correction (Deadtime correction factor)
- range_bin_time (Time in seconds for each range bin of multichannel scalar card.)
- deadtime_correction_counts (Laboratory measured counts used to calculate the deadtime correction samples)
- scope_temp (Telescope temperature)
- max_altitude (Maximum altitude retrieved from multichannel scalar card.)
- laser_temp (Laser temperature)
- polarization_control_voltage (Polarization control voltage setting)
- energy_monitor (Energy output per pulse of transmitted laser beam at 532 nm (Doubled Nd-YLF))
- signal_return_co_pol (Attenuated backscatter, copol)
- detector_temp (Detector temperature)
- pulse_rep (Repetition rate, or Trigger Frequency of the laser)
- range_offset (Distance between initial range_bin and the laser flash)
- laser_fire_bin (Bin number associated with zero height and time where laser transmit occurs)
- background_signal_std_co_pol (Background signal standard deviation, copol data)
- signal_return_cross_pol (Attenuated backscatter, cross pol)
- first_data_bin (Bin number of first data. Tells where pretrigger timing ends and end of region for background data sampling)
- overlap_correction (Overlap correction factor)
- background_signal_cross_pol (Background signal, cross pol data)
|